BMW 1162014 · 2.0L Diesel

The most recent MOT test on 2025-07-08 confirms this BMW 116 remains roadworthy with no defects recorded at 113,677 miles. The consistent pass history—spanning five consecutive tests from 2022 to 2025—indicates a stable maintenance pattern, though the near-consecutive failures in October 2023 (106,089 and 106,091 miles) suggest a brief oversight rather than a systemic issue. The absence of advisories or recurring faults implies previous owners adhered to basic servicing, though the lack of defect details in any test leaves critical components—such as suspension bushes, coil springs, or binding calipers—unverified beyond visual compliance. Mileage progression averages approximately 9,473 miles annually, a rate typical for a vehicle of this age. The gap between the 2023 failure and subsequent pass (a single day) is anomalous and likely administrative rather than indicative of mechanical neglect. No extended periods of inactivity or rapid mileage spikes are evident, though the 2022–2023 interval (9,293 miles in 12 months) is marginally higher than the subsequent average. This suggests consistent use without extreme wear patterns, though the absence of pre-MOT service records means internal components—such as timing belts, differential fluid, or brake master cylinders—remain unverified. A buyer should prioritise an independent inspection of suspension integrity, particularly rear bushes and coil springs, given the 2014 model’s known wear in these areas. The brakes, while not failed, warrant closer examination for uneven wear, binding calipers, or corrosion on discs and callipers, especially if the vehicle has encountered wet or salted roads. Structural corrosion—common in BMWs—should be checked at wheel arches, sills, and subframes, with particular attention to the rear axle and exhaust mounts. The 2023 failure gap also justifies verifying the cause, as repeated near-misses at the same mileage could signal an underlying issue. Engine bay components, such as hoses and electrical connections, should be inspected for age-related degradation, as should the exhaust system for leaks or excessive corrosion.