IsItAGoodCar
Reliability Guide

Common Problems with the
1991 Bentley Continental R

The Continental R debuted at the 1991 Geneva Motor Show as Bentley first bespoke coachbuilt grand tourer in four decades, powered by the 6.75-litre turbo V8 paired with a 4-speed GM automatic transmission.

What changed for 1991

  • •UK launch of bespoke pillarless grand tourer body
  • •6.75-litre turbocharged V8 engine with GM 4L80-E automatic gearbox
  • •Hydraulic self-levelling suspension and high-pressure braking system

Common MOT watch-outs

  • !Hydraulic brake line corrosion across the rear subframe
  • !Play in front upper and lower suspension wishbone ball joints
  • !Exhaust silencer corrosion and heat shield detachment
2
Known Issues
2
Serious
0
Moderate
0
Minor

All Known Issues

Sills, Wheelarches and Subframe Corrosion

SeriousBodywork & Rust

Despite hand-crafted assembly at Crewe, the heavy steel unitary bodyshell of the Continental R is highly vulnerable to moisture and road salt entrapment along the lower outer and inner sills, rear wheelarch lips, and front bulkhead seams. Water often collects behind plastic wheelarch liners and windscreen scuttle drains, rotting hidden structural mounting points that can result in MOT structural failure and tens of thousands of pounds in specialist coachbuilding repairs.

Est. Repair Cost: £2,500–£8,000
Warning Signs:

Bubbling paint along lower sill flanges and wheelarch lips, Damp or musty smell inside front footwells after wet weather, Cracking or flaking underbody sealant near rear suspension mountings, MOT failure for structural rust within 30cm of safety-critical mounts

What to Inspect:
  • Probe along entire length of inner and outer sills with a non-marking plastic tool
  • Lift boot carpet and inspect spare wheel well and rear bulkhead seams for water ingress or brown staining
  • Inspect front scuttle drain tubes beneath windscreen wipers to ensure free drainage
  • Examine MOT history records on GOV.UK for corrosion advisories or welding repairs
Verified by IsItAGoodCar Research TeamUpdated

Hydraulic Braking System and Rear Gas Sphere Failure

SeriousBrakes

The Continental R relies on the complex Bentley twin-circuit hydraulic system operating at over 2,000 psi to power the brakes and self-levelling rear suspension. Rubber diaphragms inside the hydraulic accumulator spheres perish with age, causing the system to lose hydraulic buffering capacity. This results in heavy brake pedal resistance, hydraulic pump chatter, and rock-hard rear damping that transmits road shock directly into the coachbuilt chassis.

Est. Repair Cost: £900–£2,800
Warning Signs:

Hard wooden brake pedal feel upon initial pedal travel, Brake low pressure warning light illuminates on dashboard during braking, Rear of vehicle sits down or takes extended time to raise after starting, Extremely stiff and jarring rear suspension compliance over bumps

What to Inspect:
  • Test brake reserve by pumping pedal 20-30 times with engine off to measure accumulator discharge
  • Check hydraulic fluid sight glass or reservoir for correct green mineral fluid condition
  • Inspect metal brake lines running above rear axle subframe for rust and pitting
  • Check for hydraulic fluid leakage around rear height-control valve and strut boots
Verified by IsItAGoodCar Research TeamUpdated

Buying Tips for 1991 Bentley Continental R

  • Examine all body panels closely for signs of historic acrylic paint microblistering
  • Check that the self-levelling rear suspension sits perfectly level after standing
  • Ensure all dashboard warning lamps perform their initial self-check correctly