IsItAGoodCar
Reliability Guide

Common Problems with the
1980–1985 Lancia Delta

We've identified 1 known issue that can affect the 1980–1985 Lancia Delta. None are considered critical, but they're worth knowing about before you buy.

1
Known Issues
0
Serious
1
Moderate
0
Minor

All Known Issues

Roof Trailing Edge and Windscreen Frame Corrosion

ModerateBodywork & Rust

Unlike earlier Lancias, Integrales received improved factory cathodic dipping, but specific moisture traps remain notorious. Rainwater and road grit collect in the channel seal where the tailgate hinges mount to the roof trailing edge, causing bubbling and structural disintegration that weakens the tailgate mountings. Similar corrosion takes hold behind the windscreen rubber seal and around the front lower scuttle, requiring painstaking metal fabrication to rectify.

Est. Repair Cost: £600–£2,000
Warning Signs:

Blistering and paint bubbling along the rear edge of the roof panel above the tailgate hinges, Water dripping into the luggage compartment or dampness beneath the rear boot carpet, Rust staining creeping out from beneath the lower windscreen rubber seal onto the scuttle, Tailgate sitting unevenly or rubbing against the roof aperture due to weakened hinge metal

What to Inspect:
  • Open the rear hatch and inspect the roof gutter seam directly around the two tailgate hinges with a torch
  • Carefully lift the lower edge of the front windscreen rubber seal to check for concealed rust blisters
  • Examine the front radiator support crossmember through the bonnet louvres for water corrosion
Verified by IsItAGoodCar Research TeamUpdated

Buying Tips for 1980–1985 Lancia Delta

  • Check meticulously for structural stress cracking at the top corners of the windscreen pillars, the bulkhead-to-chassis leg joints and the rear suspension turrets.
  • Verify that the timing belts and balance shaft belts have been changed within the last two to three years or 24,000 miles on 16V models; belt failure causes catastrophic top-end damage.
  • Confirm oil pressure on a warm engine at idle: expect at least 1.0 bar at hot idle and climbing cleanly above 3.0 bar at 3,000 rpm.
  • Examine the rear roof edge above the tailgate hinges and the front scuttle area beneath the windscreen rubber for blistering and hidden corrosion.