Crank and camshaft position sensor failure causing stalls (early 2002 builds, recall R/2003/170)
SeriousEngineDVSA campaign R/2003/170 names Primera cars built between 1 January 1999 and 30 September 2002 - 111,831 UK vehicles in total - for an engine angle and position sensor fault that could cause the engine to stall and, in the worst case, refuse to restart. Because the P12 replaced the P11 in February 2002, the earliest P12 cars sit inside that window, and the fix recorded on the recall register is a quality-assured replacement crankshaft and camshaft sensor. On a twenty-year-old car the campaign is long finished, so the practical issue is a hot stall with no restart and a diagnostic bill, not a free dealer repair.
Engine dies at a junction or on overrun when fully hot and will not fire again until it cools, Long cranking or a complete no-start with the immobiliser lamp flashing, Engine management light with a stored crank or cam sensor fault code, Cutting under load with no loss of lights or stereo power
- Ask the seller to demonstrate a genuinely hot restart after the drive, with the engine at full temperature
- Have the engine control unit read for stored sensor faults even if no warning light is showing
- Check the wiring and plugs near the crank sensor cover for oil contamination, which destroys these sensors
- For February to September 2002 cars, check whether the 2003 sensor campaign was carried out while the car was new