IsItAGoodCar
Reliability Guide

Common Problems with the
2002 Nissan Terrano II (R20)

A final update for 2002 gave the model the Primera steering wheel inside and renamed it simply Terrano in Europe, with the 3.0 TDi ZD30DOHC engine already in the range from 1999; Nissan cut the UK range to SE and SVE models for spring 2004 before sales ended.

What changed for 2002

  • •Renamed as the Nissan Terrano as the Pathfinder name moved to the bigger R50 SUV
  • •3.0 TDi 16-valve ZD30DDTi engine offered from 1999 to 2006, shared with the Patrol
  • •Interior trimmed with contemporary plastics replacing the wood-effect dash

Common MOT watch-outs

  • !Frame and rear spring shim corrosion, enough to fail on structural attack
  • !Diesel emissions failures from a leaking injector seal soot build-up
  • !Worn rear shackles and bushes giving a dangerous advisory on suspension arms
3
Known Issues
2
Serious
1
Moderate
0
Minor

All Known Issues

Structural rust in sills, arches, bulkhead and frame

SeriousBodywork & Rust

The Spanish-built Terrano II was never as well protected against UK road salt as the Japanese Nissans alongside it, and the practical buying advice in the RAC's used guide is to look underneath for damage and wear, while Parkers notes the model is only worth buying as a well-checked example. On the car, that means the rear arches and jack points, the bulkhead below the windscreen, the frame rails and rear spring pads all corrode. Body panels are close to unobtainable now, so a rotting rear corner is a fabrication job rather than a bolt-on repair, and MOT testers failed cars on structural corrosion long before the engine was tired.

Est. Repair Cost: £300–£1,200 for fabricated sill, arch and floor sections; more for frame repairs
Warning Signs:

Bubbles in the paint along the rear arch radius and under the door seals, Flaking rust or a soft spot where the rear jack sits, Coolant crust or rust staining at the bulkhead below the windscreen, Rust scale falling from the frame rails or rear spring shims on inspection

What to Inspect:
  • Press on the rear arch lips and sills behind the wheels with your thumb - a repair patch or filler gives a different sound
  • Get the car over a pit or ramp and tap the frame rails and spring pads with a handle; hollow or flaking means rot
  • Lift the windscreen scuttle grille and look for coolant traces and rust at the bulkhead
  • Check the boot and load bay floor for damp, especially on former horse and panel van cars
Verified by IsItAGoodCar Research TeamUpdated

Brake pipe chafing and split rear brake lines (recalls R/2000/028 and R/2002/039)

SeriousBrakes

Two DVSA recalls cover Terrano hydraulics. R/2000/028 covers cars built from 1 January 1995 to 31 July 1997 - 4,905 UK vehicles - where the brake system's LSV pilot tube could chafe against the floorpan, thinning the wall until fluid leaked away. R/2002/039 covers cars built from July 2001 to March 2002, where interference between the steering column and the rear brake supply pipe could cause a leak. Combined with general age corrosion, the rear lines and flexis on these 4x4s are a recurring MOT failure, and a soft pedal on the test drive is the warning.

Est. Repair Cost: £200–£600 for a full set of new pipes, flexis and a bleed with ABS work
Warning Signs:

Damp brake fluid staining along the chassis rail or under the floorpan, Pedal that sinks slowly with the pressure held on, One rear wheel pulling or a warning light with no visible pad wear, Recent MOT failure or advisory marked against brake pipes or flexible hoses

What to Inspect:
  • Trace the metal brake lines along the frame and floorpan for chafe marks, kinks and rust scale
  • Pump the pedal with the engine off, then hold firm pressure for a minute: any travel means a leak or a bad master cylinder seal
  • Look up the MOT history on GOV.UK for past brake pipe failures and advisories
  • Check the free-play of the steering column where the rear supply pipe passes it on affected builds
Verified by IsItAGoodCar Research TeamUpdated

Driveline vibration cured only by a revised clutch assembly

ModerateGearbox & Transmission

The RAC's Terrano II buying guide flags a very specific owner complaint: some diesel cars suffered a driveline vibration that needed a special clutch assembly to fix, and buyers are told to find out whether the clutch has already been changed. In the real world it shows as a heavy shudder from a standstill or a buzz through the gearbox at a steady 2,000rpm, and it is caused by the damper arrangement in the flywheel and clutch rather than the gearbox itself. Because the parts are no longer stocked as off-the-shelf items, a job that used to be a £600 clutch change becomes a long-lead fabrication and sourcing exercise.

Est. Repair Cost: £600–£1,500 with a revised clutch kit, flywheel and gearbox removal
Warning Signs:

Shudder from the transmission when moving off in first or on a roundabout, A buzz or drone through the pedal and gearbox tunnel at steady cruise, Vibration that changes or disappears when the clutch pedal is held down, Heavy judder after a hot soak or when pulling away with a load

What to Inspect:
  • Pull away repeatedly on a slope with the steering locked and feel for a shudder from the transmission rather than the engine
  • Hold the clutch down at idle in neutral: if the noise changes, the damper or input shaft bearing is the cause
  • Ask whether the revised clutch assembly has been fitted and get the parts invoice, as the RAC advises
  • Take the vehicle with a loaded trailer or a couple of passengers, which makes a weak clutch obvious
Verified by IsItAGoodCar Research TeamUpdated

Buying Tips for 2002 Nissan Terrano II (R20)

  • On 3.0 TDi cars, insist on a hot and cold starting check and watch for white smoke under load
  • Check the head gasket area for coolant crust and a milky expansion tank - this is the classic big-ticket ZD30 worry
  • Buy the last SE and SVE cars for the best corrosion protection, but expect the lowest parts availability