IsItAGoodCar
Reliability Guide

Common Problems with the
2018 Peugeot Rifter

UK market launch of the Peugeot Rifter, introducing i-Cockpit technology, EMP2 front platform engineering, and modular 5- and 7-seat versatility to the family MPV class.

What changed for 2018

  • •UK launch replacing Partner Tepee with distinct SUV-inspired exterior styling
  • •Introduction of Peugeot i-Cockpit with compact steering wheel and head-up dials
  • •Engine choices spanning 1.2 PureTech (110/130hp) and 1.5 BlueHDi (75/100/130hp)
  • •Standard (5-seat) and Long (7-seat) wheelbase variants available from launch

Common MOT watch-outs

  • !Front suspension lower ball joint and anti-roll bar drop link wear
  • !Premature front brake disc scoring from urban family duties
  • !Driveshaft constant velocity (CV) joint rubber boot splits
3
Known Issues
3
Serious
0
Moderate
0
Minor

All Known Issues

1.2 PureTech Wet Timing Belt Degradation and Oil Strainer Clogging

SeriousEngine

The 1.2 PureTech three-cylinder petrol engine employs a timing belt running submerged in engine oil ('wet belt'). Heat cycling, fuel dilution from short journeys, and incorrect engine oil cause the belt's rubber compound to crack and shed fibrous debris into the oil sump. This debris clogs the oil pump pickup strainer screen, causing severe oil starvation, loss of brake vacuum assistance (due to vacuum pump oil starvation), oil pressure warning lights, and potential catastrophic engine failure.

Est. Repair Cost: £500–£1,300
Warning Signs:

Low oil pressure warning lamp flashing on dashboard under braking or cornering, Brake pedal feeling hard or stiff due to brake vacuum pump oil starvation, Engine rattling or noisy valvetrain due to degraded oil circulation, Visible surface cracking, swelling, or edge fraying on timing belt seen through oil filler

What to Inspect:
  • Remove engine oil filler cap and shine a torch inside to inspect timing belt surface for cracks, fraying, or width swelling
  • Verify full dealer or specialist service history confirming PSA B71 2312 or B71 2010 oil specification
  • Check whether the timing belt has been renewed within the revised 6-year/60,000-mile maintenance schedule
Verified by IsItAGoodCar Research TeamUpdated

1.5 BlueHDi Camshaft Drive Chain Stretch and Breakage

SeriousEngine

On 1.5 BlueHDi (DV5) diesel engines manufactured between 2018 and early 2023, an undersized 7mm timing chain links the two camshafts inside the cylinder head. Over time, the chain stretches and wears prematurely. As the chain slackens, it slaps against the cylinder head casing, creating a distinctive metallic rattle on cold start. If ignored, the chain snaps or jumps teeth, causing the pistons to strike the valves, bending the camshafts and destroying the engine.

Est. Repair Cost: £900–£2,500
Warning Signs:

Distinct metallic ticking or rattling noise from top of engine on cold startup, Rattle that quiets down as engine warms up and oil pressure builds, Engine misfire, rough idling, or check engine warning light, Sudden engine cutout and failure to restart if chain breaks

What to Inspect:
  • Listen carefully to upper cylinder head area during a stone-cold engine startup for metallic ticking or slapping
  • Check service history to confirm whether the official Stellantis revised 8mm camshaft chain and housing kit has been fitted
  • Scan for camshaft/crankshaft correlation diagnostic error codes (e.g. P0016)
Verified by IsItAGoodCar Research TeamUpdated

AdBlue SCR Tank Pump Failure and System Warning Countdown

SeriousExhaust & Emissions

The Selective Catalytic Reduction (SCR) system on 1.5 BlueHDi diesels uses an integrated urea tank containing a submerged heater, level sensor, and high-pressure delivery pump. Internal pump failure or sensor malfunction triggers a persistent 'AdBlue Fault: No restart in XXX miles' countdown warning on the instrument panel. If the mileage countdown reaches zero, the engine management system will prevent the car from starting. Replacing the complete tank assembly is standard practice.

Est. Repair Cost: £850–£1,500
Warning Signs:

'AdBlue Fault: No restart in XXX miles' countdown warning on instrument display, Engine management warning lamp and amber UREA warning light illuminated, Car will not restart once mileage countdown reaches zero, Diagnostic trouble codes P20EE, P20A2, or P208E stored in engine control unit

What to Inspect:
  • Switch ignition on and ensure no active UREA or AdBlue countdown messages appear on the instrument cluster
  • Scan OBD-II port for stored SCR or emissions fault codes
  • Check AdBlue tank filler neck for crystallized urea residue and ask if tank has been replaced under warranty
Verified by IsItAGoodCar Research TeamUpdated

Buying Tips for 2018 Peugeot Rifter

  • Inspect 1.2 PureTech wet belt with a gauge through the oil filler hole
  • Listen for metallic camshaft chain rattle on cold startup on 1.5 BlueHDi
  • Test 8-inch central touchscreen for bluetooth and Apple CarPlay connectivity
2019–2023
Check a 2018 Peugeot Rifter by Registration