2018 Audi Q7 4.0L Diesel · BP18 JYJ

The most recent MOT inspection conducted in August 2026 resulted in a pass with no recorded defects, indicating the vehicle was in a roadworthy condition at that time. Reviewing the historical data, the maintenance trend appears stable and proactive. Although the vehicle failed in September 2025 due to a malfunction with the engine MIL, the subsequent pass demonstrates that the fault was identified and rectified. This pattern of addressing specific failures suggests a level of owner attentiveness to mechanical compliance and regulatory standards. With a recorded mileage of 93,869 miles over approximately eight years, the vehicle has covered an average of roughly 11,734 miles per annum. This usage profile is considered typical for a premium SUV of this age and suggests regular, consistent use rather than excessive mileage or long periods of standing. From a mechanical perspective, this level of usage implies that while the vehicle is not a high-mileage workhorse, it has likely experienced standard wear on consumable components such as suspension bushings, brake pads, and exhaust systems, which is entirely consistent with its age and service profile. Prospective buyers should pay close attention to the tyre advisories noted in the July 2024 inspection, which highlighted significant wear on the offside front, offside rear, and nearside rear tyres. While these tyres should have been replaced since that test, it is vital to inspect the current set for any signs of uneven wear, particularly on the inner or outer edges. Uneven wear can be a symptom of underlying suspension geometry issues, such as worn control arm bushes or misaligned tracking. During your test drive, listen for any road noise or vibrations and check for any pulling to one side, which could indicate a need for a wheel alignment or suggest worn steering components. The previous failure regarding the engine MIL in 2025 warrants a thorough check of the vehicle's electronic systems. Ensure that all dashboard warning lights, including the engine management, ABS, and airbag lights, illuminate upon turning the ignition to the first position and extinguish once the engine starts. Additionally, the advisory concerning the under trays suggests that while they are fitted, they may require inspection for secure fastening or minor damage. Finally, given the mileage, verify the service history for scheduled maintenance of the drivetrain and check for any signs of fluid leaks or corrosion on the underside of the engine and gearbox during a visual inspection.