2006 Honda CR-V I-Ctdi SE 2.2L Diesel · HG06 WBY

The most recent MOT test for this 2006 Honda CR-V I-CTDI SE, conducted on 30 November 2024 at 154,508 miles, resulted in a failure without recorded defects , an unusual outcome that warrants immediate clarification. The preceding four tests—all passed with no advisories—were conducted at intervals of approximately 12 to 18 months, suggesting a consistent, if not overly diligent, maintenance routine. The failure itself, however, implies either a procedural error in testing or a critical component failing just outside the MOT’s detection thresholds. Given the lack of defects in prior tests, this single failure does not indicate a worsening trend, but it does signal the need for verification of the test’s specifics, particularly whether any hidden faults were overlooked or if the vehicle was tested under suboptimal conditions. The mileage progression of 154,508 miles today, with the last test just 8 months ago, reflects a steady accumulation of roughly 7,700 miles annually—typical for a vehicle of this age. The gaps between tests are irregular but not extreme: the longest interval between passes was 13 months (from June 2021 to October 2022), while the shortest was 11 months (May 2019 to June 2021). There is no evidence of prolonged inactivity or aggressive driving, though the absence of advisories in any test suggests minor issues—such as worn suspension bushes or brake pad wear—may have been ignored or not yet severe enough to trigger a fail. The lack of corrosion advisories in prior tests is notable, as it implies either regular underbody checks or a sheltered parking history. Given the absence of recorded defects in prior MOTs, a buyer should prioritise a thorough inspection of suspension components , particularly the rear coil springs and bushes, which are prone to fatigue in a vehicle of this age and mileage. The failure in November 2024, despite no defects being logged, raises suspicion of binding rear brakes or exhaust system leaks , both common fail points that might not always trigger a defect but could indicate underlying wear. Structural integrity should also be assessed, particularly around the wheel arches and sills, for signs of corrosion that may not have been visible during previous tests. The engine’s DPF (Diesel Particulate Filter) and EGR system , common failure points in TDI engines, warrant inspection, as would the turbocharger for oil leaks or performance degradation. Finally, the transmission fluid and coolant levels should be checked for contamination or excessive degradation, as these fluids degrade over time and can lead to catastrophic failure if neglected.