2012 Triumph Bonneville 0.9L Petrol · KV62 AHL

The Triumph Bonneville’s most recent MOT test on 2023-11-01 resulted in a rare dual entry—one pass and one immediate fail—yet no defects were recorded in either instance. This suggests the test centre may have encountered procedural anomalies rather than genuine mechanical issues. The preceding tests in 2022 and 2021 both passed without failings, indicating a stable roadworthiness trend over the past four years. However, the lack of any advisories or defects across all four tests does not preclude the need for a thorough independent inspection, particularly given the vehicle’s age and the unusual dual MOT entries. The recorded mileage of 2,672 miles at the most recent test reflects an exceptionally low annual average of approximately 191 miles over the past decade. This suggests the bike has either been stored for prolonged periods or used very lightly, which can accelerate degradation of components like suspension bushes, coil springs, and fuel system seals due to inactivity. The gap between tests—ranging from 11 to 13 months—is standard, but the negligible mileage accumulation raises concerns about fluid changes, chain maintenance, and potential corrosion from prolonged static storage. No advisories in the MOT history imply these areas were either overlooked or not severe enough to fail testing. Given the sparse defect record, a buyer should prioritise inspecting the suspension for dried-out or cracked bushes and deteriorated coil springs, as low mileage often correlates with stiff or seized components. The braking system, while never flagged, warrants scrutiny for binding calipers or warped discs, especially if the bike has been stationary for extended periods. Corrosion checks are critical—focus on the frame’s underside, exhaust system, and wheel arches, as rust can compromise structural integrity even without visible surface deterioration. Finally, the dual MOT entries warrant confirmation that the test centre’s software or administrative process was not the cause of the fail, as this could indicate a broader issue with the record.