2016 BMW 3302.0L Hybrid Electric (Clean)

This BMW 330i demonstrates a consistent roadworthiness record with no defects recorded across all four MOT tests, most recently passing on 23 August 2025 at 64,583 miles. The absence of advisories or failings suggests the vehicle has undergone regular, compliant maintenance within the legal thresholds, though the 2023 test—conducted at 52,318 miles—marks a notable 10-month gap before the 2024 retest. This interval is within the standard 12-month MOT cycle, but the lack of intervening issues implies either diligent owner oversight or a vehicle prone to minor wear that hasn’t yet escalated. No recurring faults are evident in the record, which is uncommon for a vehicle of this age and mileage, where suspension bushes, coil springs, and brake caliper binding are typically the first to fail. The mileage progression of approximately 6,458 miles annually aligns with typical usage patterns for a vehicle of this age, without abrupt spikes or prolonged periods of inactivity. The most significant gap occurs between the 2021 test at 43,245 miles and the 2023 test at 52,318 miles—a 10-month interval covering 9,073 miles—yet no defects were recorded during either test. This suggests the vehicle was either stored briefly or driven consistently without immediate mechanical stress. The most recent MOT, just under a year ago, places the car at 64,583 miles, meaning it has since accumulated roughly 4,265 miles. While this is well within the average annual range, the buyer should verify whether this recent mileage has been driven under typical conditions or if there have been extended periods of low usage, which could affect fluid degradation or suspension stiffness. Given the clean MOT history, the primary focus for an in-person inspection should centre on components that commonly fail or degrade at this mileage without prior intervention. The suspension—particularly the rear subframe mounts, track control arms, and coil springs—should be examined for excessive play, corrosion, or dried-out bushings, as these are often overlooked until they compromise handling. Brake discs and pads, though not flagged in tests, may require assessment for lateral run-out or uneven wear, especially if the vehicle has experienced sudden braking loads. The exhaust system should be checked for leaks or corrosion at the mid-section and rear mounts, where BMW models are prone to rust-induced failures. Finally, the structural integrity of the sills, wheel arches, and underbody should be scrutinised for signs of rust penetration, as this is a critical failure point for vehicles of this age, even when MOTs pass without advisories. The lack of recorded faults does not preclude these areas from requiring attention.