2004 Volkswagen Passat 1.8L Diesel · BT04 LCL

RAC's B5 used guides give the same instruction twice: on the 1997-2000 cars, new cam belts are due every 60,000 miles so check the work has been done, and on the 2000-2005 cars it is important to check the belts have been changed on the nose at that interval. Wikipedia's Passat (B5) engine data shows what is being driven - 1.8T 20v and 2.8 V6 petrols alongside the AHU/AHH 1.9 TDI pump-duse diesels and the later 2.0 TDI - all interference engines where a snapped belt means valve damage. On a car this cheap, the belt is the single most common reason a good Passat gets written off.

RAC's B5.5 used guide tells buyers to check the CV joints and boots on higher-mileage cars, alongside confirming the power steering pump works and the air conditioning is fully gas charged. Wikipedia's engineering history for the same car explains why the four-wheel-drive examples deserve extra attention: the 4WD version was introduced in 1997 as an option on the 1.8, 2.8 V6, 1.9 TDI and 2.5 V6 TDI, used a second-generation Torsen T-2 centre differential and gave those cars fully independent rear suspension instead of the front-drive torsion beam. Grease-throwing split boots are the cheap fault; a binding driveline or worn differential is the expensive one.

Beneath the windscreen scuttle panel sits the battery, brake servo, and pollen filter housing. Two small rubber drain grommets underneath the battery tray and brake servo frequently clog with leaf litter and road silt. During heavy UK rainfall, water pools in the scuttle and rises until it overflows into the cabin through the degraded foam seal of the pollen filter housing or ECU wiring box. Water gathers in the passenger footwell where the Comfort Control Module (CCM) and loom splices reside, corroding wiring and disabling windows, central locking, and alarm circuits.