2009 Peugeot 308 1.6L Diesel · GF09 OVJ

This 2009 Peugeot 308 shows a stable roadworthiness trend over the past two MOT cycles, with no defects recorded in either the April 2024 or April 2025 tests. The most recent inspection on 1st April 2025, at 109,991 miles, confirmed full compliance across all tested categories, including brakes, suspension, emissions, and structural integrity. The single failed test in April 2024—just three miles before passing—was unusually anomalous, as no defects were logged, suggesting either a minor administrative oversight or a temporary test centre variation. The vehicle’s consistent pass status implies that major mechanical failures have been avoided, though the lack of advisories or minor faults means some wear items may have gone unnoticed. The mileage progression suggests typical usage for its age, averaging around 6,470 miles annually, which aligns with moderate long-term operation. There is a notable gap between the July 2022 test at 93,383 miles and the April 2024 tests, covering 13,266 miles over 1 year and 9 months—a rate of approximately 8,840 miles per annum. This period of higher mileage could indicate either intensive use or a prolonged period without intermediate servicing. The absence of failures during this phase suggests the vehicle was maintained adequately during this stretch, though the sudden spike in mileage may have accelerated wear on consumables like brakes, tyres, and suspension components. Given the clean MOT record, a buyer should prioritise an in-person inspection of high-wear areas that are not routinely tested. Focus on the rear suspension, as binding calipers or worn rear bushes are common in this model after 160,000 miles, though early signs of uneven tyre wear or a stiff ride could indicate pre-failure. Examine brake discs and pads for uneven wear or glazing, particularly if the vehicle has experienced rapid mileage accumulation. Corrosion should be checked at wheel arches, sills, and the subframe, as this model is prone to rust progression in wet conditions. Finally, verify the integrity of the exhaust system for leaks or sagging, as catalytic converter failure is a frequent cause of emissions-related advisories in older Peugeot models.