2017 Jaguar XJ 3.0L Diesel · PMR 20

An unblemished testing record defines the roadworthiness profile of this Jaguar XJ, culminating in a pass on 2026-02-11 following a brief initial refusal for administrative or rectifiable test bay reasons on 2026-02-03. This clean streak extends back across multiple consecutive annual examinations from 2023 through 2025, with every single test concluding without a single advisory notice or recorded component failure. Such a sequence demonstrates consistent regulatory compliance during its recent history, showing that the core structural and dynamic systems met statutory minimum standards at each annual inspection. The vehicle has accumulated a modest 32,120 miles over its nine-year lifespan, representing an average of approximately 3,570 miles annually. This low-usage profile indicates that the saloon has spent significant periods parked or restricted to short journeys rather than undertaking heavy motorway mileage. Mechanically, such light utilization patterns mean that high-stress drivetrain components have avoided rapid wear, yet prospective buyers must remain vigilant regarding static degradation, as infrequent use can place distinct pressures on rubber bushes, seals, and peripheral ancillaries that benefit from regular operational heat cycles. Although the official testing data reveals no historical defects, the combination of an aluminum-intensive architecture and low annual mileage warrants a meticulous physical examination of the underbody and suspension geometry during a pre-purchase inspection. Listen carefully during a test drive for any faint knocks, creaks, or excessive compliance from the front and rear suspension linkages, particularly when traversing speed bumps or uneven road surfaces, as heavy luxury saloons place substantial loads on their multi-link joints and air suspension components even at low mileages. Verify the operational health of the braking system by checking for any pulsation through the pedal and ensuring the electronic parking brake engages and disengages smoothly without binding. A thorough ramp inspection is essential to inspect the integrity of the undertrays, brake lines, and subframe mountings for any signs of premature environmental degradation or fluid weeping, confirming that the absence of MOT advisories translates into genuine physical robustness underneath the vehicle.