IsItAGoodCar
Year Range Hub

1985 Austin Montego

Browse our directory of 1985 Austin Montego vehicles. Access instant MOT history reports, tax status, and reliability insights for any registration listed below.

Registration Directory

Showing registrations 1–7 of 7 for the 1985 Austin Montego. Select any plate for an instant vehicle history check.

Common Problems & Reliability

1
Serious
2
Moderate
0
Minor

The 1985 Austin Montego has 3 known issues. 1 of these are classified as serious faults that could be expensive to repair. 2 are moderate concerns worth inspecting before purchase.

Rear Wheelarch and Outer Sill Seam Corrosion

Serious

Corrosion along the outer sills and rear wheelarch lips is the primary structural threat to surviving Austin Montegos. Road grit and wet salt flung into the rear wheel tubs collect along the unsealed return lip of the arch, rotting the metal from the inside outwards until blisters appear through the paint. Montego sills are particularly susceptible along their rear lower edges and the structural weld where the outer sill joins the rear three-quarter panel. Serious rot in these locations compromises seatbelt mountings and rear suspension mounting strength, resulting in mandatory MOT test failure.

Symptoms: Blistering paint and ragged rust holes along the rear wheelarch lip and rear sill ends, Crumbling metal and road grit spilling out when tapping the underside of the wheelarch return...

Est. repair cost: £400–£1,100 for fabricated arch repair sections, inner arch welding, and paint matching

O-Series Cylinder Head Gasket Oil Weeping and Crankshaft Seal Leaks

Moderate

A well-documented design characteristic of the 2.0-litre O-Series engine is persistent oil weeping from the front right corner of the cylinder head gasket face, between cylinder number four and the distributor housing. Oil gallery layout and clamping pressure variations allow oil to seep past the gasket and run down the block onto the bellhousing. In addition, the rear crankshaft main oil seal frequently hardens with age and leaks into the bellhousing, which can contaminate the clutch friction plate. While minor weeping is manageable, serious leaks require lifting the cylinder head or removing the engine to replace the rear main seal.

Symptoms: Visible engine oil pooling on the front right corner of the cylinder block beneath the distributor cap, Burning oil aroma entering the cabin through heating vents when sitting in stationary traffic...

Est. repair cost: £250–£650 for cylinder head gasket renewal, new valve cover gasket, and crank seal replacement

Bonded Windscreen Surround Rot and Cabin Water Leaks

Moderate

Like the Maestro, the Montego employs direct-bonded windscreen glass that was revolutionary in 1984 but prone to severe rust in subsequent decades. Water becomes trapped beneath the rubber finisher trim, attacking the steel pinch-weld channel along the upper roof line and the scuttle corners. Once rust perforates the aperture, water enters the cabin behind the dashboard, soaking bulkhead soundproofing and dripping into the fuse assembly. Because the glass is structural and bonded with polyurethane adhesive, a permanent repair requires cutting out the screen, welding new channel steel, and refitting new glass.

Symptoms: Water dripping into the driver and passenger footwells onto the pedals or fuse box, Damp, smelling carpets and heavy condensation inside the car after standing in rain...

Est. repair cost: £250–£750 for screen removal, scuttle welding, aperture rebuild, and glass rebonding

View detailed Austin Montego fault guide

Buying Tips for the 1985 Austin Montego

  • Give the sills, rear wheelarches, and inner front wings rigorous scrutiny; Montego sills rot severely along their rear lower lips, and outer rear arches collect damp mud that rots the metal from behind.
  • On 2.0-litre O-Series petrol engines, inspect the front right of the cylinder head gasket near cylinder number four and the distributor drive; oil seepage here is an endemic casting and gasket weakness that is stubborn to cure.
  • Check the condition of the plastic bumpers; early body-coloured bumpers suffered from excessive baking heat during factory painting, causing them to crack easily and shed paint over time.
  • On cars fitted with 365mm or 390mm TD-style alloy wheels, inspect the tyres closely; metric-sized tyres are now exceptionally rare and costly to replace, so verify whether conventional imperial wheels have been retrofitted.
  • Inspect the estate car's rear tailgate gas struts, rear bumper mounts, and self-levelling suspension (if fitted); look for sagging tail ends or cracked load-bay interior plastics on well-used family load-luggers.

Check Any Vehicle

Don't see your specific car listed? Enter any UK registration number for an instant vehicle history check — including MOT history, tax status, finance check, and write-off data.

Free Vehicle Check