2011 Proton GEN-2
Browse our directory of 2011 Proton GEN-2 vehicles. Access instant MOT history reports, tax status, and reliability insights for any registration listed below.
Registration Directory
Showing registrations 1–40 of 97 for the 2011 Proton GEN-2. Select any plate for an instant vehicle history check.
Common Problems & Reliability
The 2011 Proton GEN-2 has 5 known issues. 3 are moderate concerns worth inspecting before purchase.
CamPro S4PH Electronic Throttle Body Carbon Fouling and Idle Speed Hunting
ModerateThe 1.6-litre CamPro S4PH engine utilizes an electronic throttle body assembly that is prone to oil mist and carbon contamination from the positive crankcase ventilation (PCV) system. Over time, gummy carbon deposits accumulate around the throttle butterfly plate and idle bypass bore. This disrupts the airflow calculations of the engine control unit (ECU), causing erratic idle hunting between 600 rpm and 1,300 rpm, delayed throttle response when pulling away, and sudden engine stalling when dipping the clutch at roundabouts or traffic lights. Cleaning the throttle assembly and performing an ECU idle relearn procedure is required to restore smooth operation.
Symptoms: Engine idle fluctuating erratically between 600 and 1,300 rpm when stationary, Hesitation and stumble when gently pressing the accelerator from a standstill...
Est. repair cost: £130–£290
Rear Brake Caliper Slider Pin Seizure and Handbrake Inefficiency
ModerateThe Proton GEN-2 is equipped with rear solid disc brakes that incorporate an internal mechanical handbrake actuator lever on each caliper. Exposed to corrosive UK road salt and road wash, the rubber slider pin dust gaiters split and allow moisture into the guide bores. This causes the steel pins and internal handbrake return springs to corrode and seize. As a result, the rear brake pads drag persistently against the rotor, generating excessive brake dust, overheating the rear hubs, and leading to MOT failures for inadequate parking brake efficiency or brake effort imbalance exceeding 30 percent.
Symptoms: Handbrake lever pulls up excessively high or feels slack with minimal holding power on hills, Rear brake discs show severe grooving, blue heat discolouration, or heavy surface rust banding...
Est. repair cost: £140–£320
Front Suspension Coil Spring Fracture and Anti-Roll Bar Drop Link Play
ModerateWhile Lotus tuned the GEN-2 suspension for crisp roadholding, British speed bumps and severe winter potholes place immense stress on the front MacPherson strut assemblies. The protective plastic coating on the front coil springs chips easily from road grit, allowing road salt to initiate rust pitting along the lower pig-tail coils, which eventually fracture under compression. Concurrently, the front anti-roll bar drop link ball joints and mounting bushes wear out quickly, generating metallic rattling noises over broken road surfaces and leading to an immediate UK MOT test failure.
Symptoms: Metallic clunking or twanging noises from the front suspension when steering at low speeds, Rattling and knocking sounds over corrugated road surfaces, sunken drain covers, and potholes...
Est. repair cost: £140–£330
Manual Gear Linkage Bush Perishing and Notchy Selection
MinorThe five-speed manual transmission linkages on the Proton GEN-2 rely on rubber and nylon pivot bushings beneath the cabin centre console and along the underbody selector rods. Due to heat from the exhaust tunnel and road grime ingress, these bushings degrade, perish, and develop excessive slop. The gear selector lever loses its positive spring-loaded gate definition, resulting in an imprecise, vague shift action, difficulty selecting first gear or reverse from neutral, and occasional gear crunching into second. Replacing the worn bushings with uprated polyurethane or new factory nylon bushes restores shift precision.
Symptoms: Excessive lateral free play in the gear lever while in gear or neutral, Difficulty engaging first gear or reverse when the vehicle is stationary...
Est. repair cost: £110–£240
Door Loom A-Pillar Wiring Fracture and Central Locking Actuator Failure
MinorThe electrical wiring harness routed from the cabin body through the front A-pillar rubber accordion gaiters to the doors is prone to copper wire fatigue. Repeated opening and closing of the driver door causes the stiff insulation to crack and inner conductors to fracture. Additionally, the internal electric motor solenoids inside the door latch mechanisms gum up with dried grease. This results in intermittent or complete failure of the central locking system, doors bouncing back to unlocked after arming with the key fob, and erratic power window or electric door mirror operation.
Symptoms: One or more doors fail to lock or unlock when using the key fob or dashboard master switch, Central locking repeatedly cycles or bounces open immediately after being locked...
Est. repair cost: £90–£210
Buying Tips for the 2011 Proton GEN-2
- Check for smooth, consistent throttle response and steady engine idle; early CamPro engines suffer from a noticeable mid-range torque dip and carbon-fouled electronic throttle bodies.
- Test the five-speed manual gear selector across all gates, ensuring clean engagement of first and reverse gears without excessive lever play caused by perished nylon linkage bushes.
- Inspect the rear brake calipers and handbrake lever operation on a steep incline; sliding pins and handbrake pivot mechanisms frequently seize in wet UK winters.
- Verify that all central door locking actuators cycle simultaneously when pressing the key fob; broken wiring within the front A-pillar door gaiters is a common electrical gremlin.
Check Any Vehicle
Don't see your specific car listed? Enter any UK registration number for an instant vehicle history check — including MOT history, tax status, finance check, and write-off data.
Free Vehicle Check