IsItAGoodCar
Reliability Guide

Common Problems with the
1995 Alfa Romeo 145 & 146

The 145 hatchback and 146 fastback launched in the UK in 1995, featuring Chris Bangle and Walter de Silva styling and charismatic flat-four Boxer petrol engines.

What changed for 1995

  • •UK launch of the 145 3-door hatchback (Chris Bangle design) and 146 5-door fastback (Walter de Silva)
  • •Longitudinal flat-four Boxer petrol engines: 1.6 8V (103PS) and 1.7 16V (129PS)
  • •Innovative cutaway passenger dashboard design to increase interior knee space
  • •Front MacPherson strut suspension with rear trailing arm independent setup

Common MOT watch-outs

  • !Floorpan seam, inner sill, and jacking point structural corrosion
  • !Excessive exhaust CO emissions on Boxer engines from tired lambda sensors
  • !Front brake disc corrosion and sticking single-piston brake calipers
2
Known Issues
1
Serious
1
Moderate
0
Minor

All Known Issues

Floorpan, Sill, and Inner Arch Corrosion

SeriousBodywork & Rust

The 145 and 146 were built prior to comprehensive modern zinc galvanising. Moisture trapped beneath factory underseal, behind plastic wheel arch liners, and within structural sill sections causes severe rusting. In the UK, road salt rots the floorpan seams, jacking points, and front bulkhead seams, resulting in structural MOT failures if neglected.

Est. Repair Cost: £450–£1,500 (cutting out rust and welding new steel panels)
Warning Signs:

Crumbling metal around the four designated jacking points, Surface rust bubbling along lower sill edges and rear wheel arch lips, Wet footwell carpets from rainwater ingress through rusted inner wing seams, MOT advisories or failure certificates for structural corrosion near suspension anchorages

What to Inspect:
  • Inspect the entire underside of the car on a ramp, paying close attention to floorpan seams
  • Push firmly against inner sill sections and jacking points to detect soft or hollow metal
  • Lift the boot carpet to inspect the rear floorpan and spare wheel well for rust holes
Verified by IsItAGoodCar Research TeamUpdated

Rear Trailing Arm Bearing Wear

ModerateSuspension & Chassis

The rear suspension on the 145 and 146 utilizes trailing arms pivoting on needle roller bearings housed in the rear crossmember. Road dirt and water wash past degraded grease seals, causing the needle bearings to seize, wear, and collapse. This results in severe negative rear wheel camber, rear tyre scrubbing on inner arch liners, and loose, unstable handling.

Est. Repair Cost: £220–£450 (bearing repair kit or trailing arm overhaul)
Warning Signs:

Noticeable negative camber with the tops of rear wheels leaning heavily inwards, Creaking, groaning, or metallic clicking from the rear suspension over bumps, Uneven wear on the inside edges of both rear tyres, Rear of the vehicle feels unstable or unsettled when cornering on rough asphalt

What to Inspect:
  • Stand behind the car on level ground and check if rear wheels lean inwards at the top
  • Jack up the rear and grasp each tyre at 12 and 6 o'clock to check for play in the trailing arm pivot
  • Inspect inner rear wheel arch liners for scuff marks from tyre contact
Verified by IsItAGoodCar Research TeamUpdated

Buying Tips for 1995 Alfa Romeo 145 & 146

  • Inspect the underside on a ramp for MOT rust repair welding around floor drain plugs
  • Listen for smooth cold-start idle and check for blue exhaust smoke on Boxer engines
  • Check front tyres for uneven shoulder wear indicating misaligned tracking