IsItAGoodCar
UK Buyer Reliability Guide5 Known Faults Documented

Nissan GT-R (R35) Common Problems & Reliability

Nissan dropped the Skyline name for its 2009 supercar and sold the R35 GT-R here from April 2009 with a hand-built 3.8-litre VR38DETT twin-turbo V6 making 478-485hp, a six-speed dual-clutch semi-automatic sending power to all four wheels and 0-60mph in 3.9 seconds. Official UK GT-R sales had previously only ever been small runs of R33 and R34 Skyline cars, which is why the R35 - initially a fraction of Porsche money - created a whole used market. Parkers tracked the model's steady evolution: 565-570hp and a much better-behaved dual-clutch from the 2017 revisions, a 600hp Nismo introduced in 2016, and a cabin retrimmed at the end of 2016 to hide the earlier cheap plastics. RAC's survey found very few engine problems even on 600-750hp tuned cars, but gearbox control solenoid failures on early cars, the unsolvable bell housing rattle and brutal tyre, brake and clutch consumption are the ownership headlines. Parkers and the RAC both date UK sales to 2022.

5
Generation Periods
5
Known Issues
2
Critical Faults
3
Moderate Issues

Select a Model Year Period

Detailed fault breakdown, symptoms, and estimated repair bills by production year.

Most Common Nissan GT-R (R35) Faults & Repair Costs

High Risk

Dual-clutch gearbox control solenoid wear and harsh low-speed shifting

Est. Cost£900–£2,500 for solenoid and mechatronic work; £4,000–£8,000 if the gearbox must be removed and rebuilt

RAC's GT-R used guide reports that early cars suffer gearbox control solenoid problems that wear or break internal components, and that the resulting repair is expensive because the whole transmission has to come out of the car; their test advice is simply to check that ratio changes are clean and smooth. Parkers backs up the other half of the picture - the dual-clutch automatic was noticeably jerky at urban speeds until the 2017 revisions. In practice the fault shows as a shudder or delay from a standstill, reluctance to select a ratio when hot, and a mechatronic unit that a specialist will quote four figures to rebuild.

Warning Signs:

Judder or shudder pulling away from a standstill, worse when hot, Delayed or clunky ratio changes on a kickdown, or a flare between gears, Transmission warning lamp or a Limp mode that holds the car in a single gear, Grumbling or whine from the transmission at parking speeds

What to Check Before Buying:
  • Drive the car cold and then again after twenty minutes in traffic, and count the engagements from stationary - they must be smooth both times
  • Ask for evidence of dual-clutch fluid being changed and of any gearbox software adaptation being done at a Nissan specialist
  • Have the car plugged in for transmission fault history, not just a live check with no warning light
  • Look for track-day evidence and overheating, because clutch and solenoid life is where abused cars end up
Verified by IsItAGoodCar Research TeamUpdated
Moderate Risk

Brake, tyre and clutch consumption from road and circuit use

Est. Cost£354–£430 per tyre (£1,400–£1,750 per set); £600–£1,200 for Brembo pads and discs per axle; £1,320 for a clutch

The GT-R is honest money for performance but ruinous to live with if the previous owner used it properly. RAC's guide warns of the running costs: a clutch will set you back around £1,320, an exhaust is around £1,417, and tyres are £354 front and £429 rear - so a full set easily runs to £1,500. Parkers agrees that tyres and Brembo brake pads and discs wear rapidly under hard track use, and that early CBA models eat consumables faster than the later DBA and 4BA cars. On viewing, inspect the front and rear disc faces for heavy heat-crazing and lip wear (new discs and pads cost £600 to £1,200 per axle), check tyre wear evenly across all four tyres, and ask for a recent diagnostic read-out of clutch wear capacities.

Warning Signs:

Heavy lip or circumferential grooves on Brembo brake discs, Inner shoulder tyre wear on 20-inch run-flat rubber, Clutch slip or slow engagement when pulling away from cold

What to Check Before Buying:
  • Check all four tyre brand names match and tread is above 3mm across the whole width
  • Feel across front and rear discs through the alloys for lips or grooving
  • Ask the seller or specialist for the Consult diagnostic clutch wear and touch point history
Verified by IsItAGoodCar Research TeamUpdated
Moderate Risk

Flywheel bellhousing bearing play and idle rattle

Est. Cost£750–£1,400 for specialist upgraded bearing and housing assembly

The factory primary driveshaft bearing in the flywheel bellhousing develops excessive clearance within its aluminium casing, producing a characteristic metallic rattle or marbles-in-a-tin-can chatter from underneath the centre console at idle. While initially an acoustic defect that quietens once drive or reverse is engaged under torque load, severe bearing wear creates noticeable drivetrain vibration and can lead to housing failure. Nissan replaced housings under warranty with identical factory components that often failed again; UK specialists such as Litchfield developed upgraded fixed-roller-bearing sleeved assemblies.

Warning Signs:

Metallic rattling or marbles-in-a-tin-can chatter from under the centre console at idle in Park or Neutral, Rattling noise diminishes or changes pitch immediately when shifted into Drive or Reverse, Noticeable driveline vibration felt through the cabin floor and seat base at low engine revs, Excessive lateral and radial play detected in the prop shaft input bearing during ramp inspection

What to Check Before Buying:
  • Allow the engine and transmission to reach full operating temperature, then listen for rattling underneath the cabin while idling in Park
  • Shift between Park, Neutral, Drive and Reverse to verify whether the rattle alters pitch under torque load
  • Inspect maintenance records for an upgraded replacement bellhousing assembly fitted by a recognised GT-R specialist
  • Have a specialist inspect the bellhousing on a four-post vehicle lift to measure bearing play before purchasing
Verified by IsItAGoodCar Research TeamUpdated
High Risk

Electronic steering column lock (ESCL) failure causing no-start

Est. Cost£450–£850 for replacement lock unit and coding; £100–£250 for aftermarket emulator module

Early R35 GT-R models (particularly 2009 to 2011 builds) suffer from steering column lock unit failure, where the internal motor or microswitch mechanism jams due to lubricant migration and wear. When the steering lock fails to cycle, the vehicle immobiliser fails to confirm unlock status, the yellow KEY or steering lock warning lamp illuminates on the dashboard, and the ignition will not cycle to the ON position, completely preventing the engine from starting. Nissan issued voluntary service campaigns, but unaddressed cars require replacement lock mechanisms or specialist bypass emulator modules.

Warning Signs:

Engine fails to crank and ignition will not switch to ON when pressing the start button, Yellow KEY warning light or steering lock warning icon illuminated on the instrument binnacle, Steering wheel remains locked in place or fails to lock after switching off and exiting the vehicle, Vehicle completely immobilised despite a healthy 12V battery and functional key fob

What to Check Before Buying:
  • Cycle the ignition start button several times while listening for the distinct whir/click of the steering column lock engaging and releasing
  • Check vehicle service history and campaign records to confirm whether the Nissan steering lock campaign was performed
  • Verify that no persistent yellow key warning icons remain illuminated on the binnacle after entering the car
  • Inquire whether a revised Nissan lock assembly or a specialist steering lock emulator has already been fitted
Verified by IsItAGoodCar Research TeamUpdated
Moderate Risk

Bilstein Damptronic adaptive damper fluid leaks and electronic suspension failure

Est. Cost£900–£1,600 per axle for replacement OEM Bilstein dampers; £2,500–£3,500 for a full upgraded suspension kit

The electronically controlled Bilstein Damptronic shock absorbers fitted across the GT-R range are prone to hydraulic fluid misting and weeping past the main rod seals, exacerbated by the car's 1,740kg kerb mass and firm damping over corrugated UK asphalt. Leaking dampers degrade high-speed stability, cause front-end float and uneven tyre wear, and result in immediate failure or advisory notes on UK MOT inspections. Replacement OEM Bilstein dampers from Nissan franchises carry steep supercar pricing, prompting owners to source specialist rebuilds or complete aftermarket coilover packages.

Warning Signs:

Oily misting, wet hydraulic fluid stains or road dirt encrustation visible on shock absorber bodies, Bouncy, floaty or uncontrolled body rebound over crests and undulating road surfaces, Uneven tyre wear across inner and outer tyre shoulders caused by compromised damping control, Advisory notice or refusal of test certificate on MOT for fluid leakage from shock absorber

What to Check Before Buying:
  • Inspect all four Bilstein damper bodies through the wheel spokes with a torch to identify hydraulic weeping or oil residue
  • Switch between Comfort, Normal and R suspension settings on the dashboard toggle to verify discernible change in damping firmness
  • Check past MOT test history for previous advisories or failures regarding leaking dampers or suspension joints
  • Push down firmly on each corner of the bodywork to confirm positive resistance and immediate settling without multiple rebounds
Verified by IsItAGoodCar Research TeamUpdated
Essential Pre-Purchase Step

Buying a used Nissan GT-R (R35)? Always check for hidden finance and write-off history.

Mechanical problems are only half the battle. Over 1 in 3 UK used cars checked have unpaid finance or accident write-off records that could cause you to lose the car or thousands in value.

Inspection Checklist for Nissan GT-R (R35) Buyers

Verify the whole recall and service story by VIN before buying, and note that DVSA campaign R/2021/188 covers steering knuckles on cars built between August and October 2020.
Insist on evidence of the dual-clutch fluid and clutch being serviced on schedule, particularly if the car has done track days - the RAC's specific warning is that circuit use is fine provided servicing was regular.
Get the transmission to prove itself cold: pull away from a junction, creep through traffic and use kickdown, and walk away from delayed, juddering or clunky changes, because solenoid wear means the gearbox has to come out.
Accept the bell housing rattle as a characteristic rather than a fault, but listen for it changing with clutch pedal position and have a specialist confirm the flywheel and bearing condition.
Budget for consumables at supercar rates: the RAC priced front tyres at around £354 and rears at around £429 on Bridgestone Potenza RE070 rubber, a clutch assembly near £1,320 and a Milltek exhaust about £1,417.
Buy the least modified car you can, from an owner who can show track and maintenance records, because a 700hp tuned car is worth less to a next buyer than a standard one with a clean history.