2018 Peugeot Expert 2.0L Diesel · AJ18 ETT

On BlueHDi diesel engines across the Expert (K0) range, the AdBlue emissions SCR system is prone to premature failure. The dosing pump, heating element, and level sensors are integrated directly into the non-serviceable plastic tank assembly. Chemical crystallization of urea liquid, heating element burnout, and internal pump motor seizure cause emissions system fault codes and trigger a mandatory non-start countdown on the dash. Once this countdown reaches zero miles, the engine is immobilised until the entire tank assembly is replaced.

The 1.5-litre BlueHDi (DV5) diesel introduced from 2018 utilizes a secondary 7mm timing chain to drive the second camshaft from the first, operating in addition to the standard timing belt. Under thermal stress and carbonaceous oil contamination, this small chain stretches prematurely, rattles against its plastic guides, and snaps. A snapped chain causes immediate piston-to-valve contact, shattering rocker arms, bending valves, and destroying the cylinder head. Peugeot subsequently revised the cylinder head assembly to accept an 8mm heavy-duty chain.

The side sliding loading doors on the Expert (K0) endure heavy daily commercial use in the UK. The nylon center and lower guide rollers wear out, become contaminated with grime, or disintegrate, causing the door to drop, stick, or scrape along the exterior quarter panel. On models fitted with hands-free electric sliding doors, worn rollers or dirty electrical B-pillar contact pads trigger resistance sensors, causing the door to stall halfway or refuse to latch shut properly.