1985 Yamaha T80 0.1L Petrol · B67 BEG

This Yamaha T80 has maintained a consistent MOT pass status across three consecutive tests, with the most recent inspection on 20 June 2024 confirming no defects at 25,392 miles. The absence of advisories or failings in any of the three recorded tests—spanning 2022 to 2024—indicates a stable roadworthiness trend, though the vehicle’s age (nearing 41 years) means mechanical wear will inevitably demand closer scrutiny beyond the MOT’s scope. The last test occurred just over two years ago, which is well beyond the standard three-year MOT interval, raising questions about whether the vehicle has been regularly driven or stored. While the MOT record shows no red flags, the prolonged gap between tests suggests the buyer should verify whether critical components like suspension bushes, coil springs, and binding calipers have been serviced or replaced since the last pass. The recorded mileage of 25,392 miles over approximately 41 years equates to an exceptionally low annual average of around 619 miles, far below typical usage patterns for a classic motorcycle. This suggests either minimal riding, prolonged storage, or a combination of both. There are no visible gaps in the MOT history that would indicate periods of neglect, but the lack of recent testing—particularly with a vehicle of this age—means corrosion risks, such as structural frame rust or seized pivot points, could have developed undetected. The consistency in mileage between tests (around 175–275 miles per year) further implies the bike has not been subjected to heavy or variable use, which could either preserve components or accelerate wear in specific areas. Given the absence of MOT-reported faults, the primary focus for an in-person inspection should centre on high-wear items that fall outside the MOT’s remit. The suspension—particularly the rear shock absorbers and front forks—should be checked for leaks, stiffness, or excessive play, as rubber bushes and seals degrade over decades of inactivity. Brake discs and pads, while not flagged in tests, may exhibit uneven wear or corrosion if the bike has been stored without use, and caliper binding could occur if seals have dried out. The drivetrain, including the chain and sprockets, warrants inspection for rust or elongation, while the electrical system—especially wiring and connectors—could suffer from oxidation or brittle insulation after prolonged disuse. Finally, a thorough examination of the frame, fuel system, and exhaust manifold for corrosion is essential, as these areas are prone to deterioration in a motorcycle of this vintage and low mileage.