2006 Citroen Berlingo M-S XTR 16V 1.6L Other · BC03 MMC

The Citroën Berlingo in question has maintained a consistent MOT pass record across four consecutive tests, with no defects or advisories recorded in any of the most recent examinations. The November 2025 test at 109,358 miles confirms the vehicle remains roadworthy under current DVSA standards, though this does not preclude underlying issues that may not have been detected during testing. The absence of recurring faults suggests either diligent maintenance or a vehicle that has not yet reached critical wear thresholds for its age. However, the lack of advisories in prior tests—particularly in 2023 and 2022—implies no prior warnings of impending failures, which could either reflect proactive servicing or a vehicle that has been neglected until the last possible moment before testing. The recorded mileage of 109,358 miles over approximately 20 years equates to an average of around 5,468 miles annually, which is unusually low for a vehicle of this age and category. The gaps between tests are consistent with this pattern: the most recent MOT in November 2025 follows a 12-month interval from October 2024, while the 2023 test occurred just over a year after the 2022 examination. There is no evidence of rapid mileage accumulation or prolonged periods of inactivity, though the low annual mileage does raise questions about whether the vehicle has been stored for extended periods, which could accelerate certain forms of degradation such as suspension corrosion or battery sulphation. The steady progression of mileage without spikes suggests minimal high-use wear, but it also implies potential for deferred maintenance if the vehicle has not been regularly driven or serviced. Given the clean MOT history, a buyer should prioritise an in-person inspection of high-wear components that are not routinely tested during MOTs. The suspension—particularly the coil springs, bushes, and dampers—should be examined for uneven wear, excessive play, or corrosion, as these are common failure points in older vans that may not have been flagged in testing. The brake system warrants close scrutiny, including the condition of the brake discs for scoring or uneven wear, as well as the caliper slides for binding or corrosion. Structural integrity is another critical area; the floor pans, sills, and wheel arches should be inspected for rust penetration, especially in the UK’s chloride-laden environment, as this can compromise the vehicle’s load-bearing capacity. Finally, the exhaust system should be checked for leaks or excessive corrosion, particularly around the catalytic converter and muffler, as these are often overlooked but can lead to emission failures or structural weaknesses.