2018 Audi Q5 2.0L Petrol · BF18 KXA

A consistent history of clean MOT results defines this vehicle, with no recorded structural or mechanical failures across its entire testing history from 2021 through to the most recent test on 27 July 2026. While the most recent inspection involved a failure regarding the front windscreen wiper failing to clear the glass effectively, this was a minor non-mechanical defect that was rectified to achieve a pass. The absence of any recorded advisories for brake wear, tyre condition, or suspension components across six consecutive years suggests a stable roadworthiness profile regarding the primary safety systems. The recorded mileage of 38,693 miles indicates a low-usage pattern for an eight-year-old vehicle, averaging approximately 4,837 miles per year. This level of annual accumulation is significantly lower than the UK average, which typically implies less frequent wear on high-friction components such as brake discs, pads, and tyres. However, such low mileage can also mean the vehicle has spent extended periods stationary, which can occasionally lead to the drying out of rubber seals or the uneven settling of suspension components. Given the lack of recorded advisories for suspension or steering, a test drive should focus on verifying that the low mileage has not resulted in any stiffness or hesitation in the steering rack or electronic power assistance. Listen for any subtle knocking or clunking sounds when traversing uneven surfaces, which would indicate that suspension bushes or coil springs may have aged or seized due to infrequent movement. Pay close attention to the smoothness of the ride and ensure there is no pulling to one side under braking, which would suggest uneven pad deposits or binding calipers despite the clean MOT record. Because there are no recorded oil leaks or emissions failures, the drivetrain appears to have maintained its integrity through its testing cycles. During the test drive, monitor for any unusual engine vibrations or changes in exhaust note that might suggest issues with mounts or exhaust manifold sealing. While the recent wiper failure was a simple visibility issue, ensure the entire wiper assembly and washer system function correctly to confirm that no further minor peripheral defects remain unaddressed.