2022 BMW M240I Xdrive Auto 3.0L Petrol · DE22 FHA

The vehicle presents a stable and compliant roadworthiness profile. The most recent DVSA test on 23 July 2025 at 27,558 miles returned a clear pass with zero recorded defects, placing the certificate just under twelve months from the current date. The preceding inspection on 25 February 2025 at 25,292 miles also cleared without advisories or minor faults. This consecutive clean record indicates a resolving maintenance trajectory rather than a pattern of deferred repairs. The tester found no binding calipers, degraded suspension bushes, or compromised structural integrity at either checkpoint. The absence of recurring advisories suggests the previous owner addresses wear items promptly before they escalate into failure points. The odometer reading aligns with expected usage for a 2022 registration, averaging roughly 6,890 miles annually. The vehicle accumulated 2,266 miles between the February and July tests, a moderate run that places normal stress on the drivetrain and braking system without indicating excessive motorway mileage or prolonged storage. Consistent annual distances typically preserve engine seals and transmission fluid integrity better than erratic usage cycles. The clean MOT history combined with steady mileage accumulation points to disciplined service intervals and routine component replacement. A prospective buyer should verify performance-specific wear items that fall outside standard MOT scrutiny. The record shows no failures related to minor consumables such as wiper blades or tyre tread, which indicates routine upkeep was maintained. Physical inspection must therefore focus on serious mechanical risks typical of high-output models. Check the front and rear brake discs for lateral runout and surface scoring, as aggressive driving cycles accelerate pad and rotor degradation. Examine the suspension mounting points and control arm bushes for rubber perishing or micro-fractures. Verify the exhaust system for heat-induced cracking near the turbo manifold and confirm emission levels remain within manufacturer tolerances during a cold start. Ensure differential oil and coolant show no signs of contamination or breakdown. All structural welds and underbody panels require a thorough visual sweep to rule out hidden corrosion or impact damage.