1972 Lancia Fulvia 1.3L Petrol · EKP 834K

The front subframe carries the entire weight of the canted V4 engine, transmission, steering idlers and transverse leaf suspension. Water and mud thrown up by the front tyres settle into the enclosed mounting boxes, rear outriggers and inner wing attachment points, causing severe structural rot. In advanced stages of corrosion, structural stress causes vertical cracks to propagate through the front wheel arches and allows the subframe to twist under cornering loads.

Most production Fulvias breathe through twin sidedraught Solex (or Dell'Orto/Weber) carburettors feeding the narrow-angle V4. Over time, vibration, linkage wear and degraded rubber mounting blocks cause the throttle butterflies to fall out of synchronisation. An unbalanced fuel mixture causes lumpy idling, persistent hesitation off idle, bore fuel washing, fouled spark plugs and hot-starting difficulties on UK pump fuels.

Fulvias rely on four-wheel disc brakes: early Series 1 cars use Dunlop calipers without servo assistance, while Series 2 and 3 models use Girling calipers with an independent rear handbrake caliper mechanism. Infrequent use and damp UK garage storage lead to caliper piston pitting, binding pads, uneven braking balance and seized handbrake pivots, resulting in severe drag and overheated rear discs.

The narrow-angle V4 relies on a compact water pump and narrow aluminium cylinder head cooling jackets. Over decades of ownership, infrequent coolant flushing and the use of tap water cause silt buildup and galvanic corrosion in the radiator and waterways. Impellers erode and the mechanical water pump seal weeps, causing creeping temperatures in traffic, localized cylinder head hotspots and eventual head gasket failure.