2010 Volkswagen Polo 1.2L Petrol · EN10 ABO

The most recent MOT, conducted on 13 December 2024 at 129,962 miles, resulted in a pass, yet the record reveals a vehicle with persistent, unresolved mechanical faults rather than one in sound overall health. The maintenance trend is stable but concerning, as several advisories from the failed test the previous day on 12 December 2024 at 129,937 miles carried forward into the pass. The tester noted an oil leak from the gearbox, slight play in the offside front suspension arm ball joint, worn front anti-roll bar D bushes, and both front coil springs not fully seated at the top. Rear brakes were imbalanced and only just met minimum requirements, with the brake pedal exhibiting noticeable drop and the parking brake adjustment sitting high. These are not fresh defects. They represent a pattern of deferred maintenance stretching back several years. Mileage accumulation tells a consistent story. Between the December 2022 test at 94,853 miles and December 2023 at 110,770 miles, the car covered roughly 15,900 miles in a single year, a significant spike compared to the 19,192 miles added over the following twelve months to December 2024. At sixteen years old with 129,962 miles recorded, the annual average of approximately 8,123 miles is typical for its age, but the uneven distribution suggests periods of heavier use interspersed with quieter spells. The gap between the 2023 and 2024 tests shows a notable increase in the rate of accumulation, which places additional stress on components already flagged as worn. The recurring brake issues demand serious attention. Rear brake imbalance appeared in the December 2022 failure, the December 2023 pass, and again in both December 2024 tests. Combined with persistent brake pedal drop and a high parking brake lever, this points to a braking system that has not received proper adjustment or hydraulic attention for at least four years. A buyer should have the entire braking system inspected, including calipers for binding, rear brake wheel cylinders for leakage, and the hydraulic system for air or fluid deterioration. The front suspension requires close examination. Both front coil springs not seating fully at the top is an unusual and potentially dangerous condition that risks sudden spring displacement under load. The worn ball joint and anti-roll bar bushes compound this concern, suggesting the front end has been neglected. A thorough physical inspection of the spring seats, top mounts, and subframe for corrosion or damage is essential before purchase.