2007 Hyundai Santa FE 2.7L Petrol · ET56 DUH

A signature fault of this generation's CRDi diesels: worn injectors with excessive return flow, or a failing pump metering valve, drop the common rail below the pressure needed to start or keep running. A UK diagnostic case that ran through this forum thread saw a Santa Fe given a second-hand high-pressure pump, new metering valve, new regulator, rail sensor and even a used ECU before the real cause was traced - classic example of the expensive parts-swap merry-go-round workshops fall into. Symptoms are hot no-starts, starting on starter fluid then never restarting, and low-pressure codes such as P1181 hidden behind intermittent limp.

A serious safety defect affecting second-generation Santa Fes led to multiple DVSA recall campaigns (including R/2020/223). Moisture ingress into the Hydraulic Electronic Control Unit (HECU) causes an internal electrical short circuit across the printed circuit board. This leaves the ABS module continuously energised even after the engine and ignition are switched off, draining the 12V battery and creating an engine bay fire risk. Dealership remedy involves installing a dedicated power-supply relay in the engine bay fusebox to isolate the unit when the ignition is switched off.

Corrosion of underbody suspension components and rear subframes is the dominant MOT failure point on UK Santa Fe CMs, driven by heavy road salting. DVSA MOT test data shows worn suspension pins, bushes and joints account for over 30% of failures, alongside excessive component corrosion at nearly 13%. Rear trailing arm bushes perish, leading to wheel misalignment and harsh thuds over uneven tarmac, while the pressed-steel rear suspension arms and subframe mounting points suffer severe structural flaking that warrants immediate MOT rejection.