2024 Iveco Daily 35S14B Diesel · FN74 XCX

Without any recorded MOT entries, there is no documented evidence of this 2024 Iveco Daily 35S14B having been examined for roadworthiness under the DVSA scheme. The absence of both pass and failure results means that the vehicle’s compliance with safety and emissions standards cannot be confirmed, and any assessment must rely entirely on a fresh, independent inspection rather than a proven testing history. Mileage data is also missing, so no comparison can be drawn between kilometres driven and the vehicle’s age. Without an odometer reading, it is impossible to gauge annual accumulation rates, identify periods of intensive use, or detect unusually low or high mileage that might hint at premature wear or prolonged inactivity. The lack of mileage information further underscores the need for a thorough visual and mechanical survey before any purchase decision. A prospective buyer should therefore arrange a comprehensive pre‑purchase inspection that covers the primary systems of a commercial van of this class. Particular attention should be paid to the front and rear suspension assemblies—checking for worn bushings, cracked mounting points, and any looseness in the coil springs or leaf springs under load. The steering rack, tie‑rod ends and steering column should be inspected for play or corrosion, while the brake system requires a close look at the condition of the discs, pads, caliper pistons and flexible brake pipes for signs of cracking, rust or fluid leakage. During a test drive, listen for any knocking or clunking over bumps that could indicate deteriorated suspension components, and feel for any steering pull or vibration that might reveal alignment or tyre issues. Apply the brakes firmly to detect judder, pulsation or an unusually long pedal travel, which could point to warped discs or air in the hydraulic circuit. Finally, verify that the engine runs smoothly at idle and under load, with no excessive smoke, abnormal noises or warning lights, and ensure that the exhaust system is free of leaks or corrosion that could affect emissions compliance. A full diagnostic scan and a professional mechanical appraisal are essential before committing to purchase.