2022 Volkswagen Golf Style TSI E-Hybrid S-A 1.4L Hybrid electric (clean) · GF72 LSV

Suspension component wear and visibility issues define the current mechanical profile of this vehicle, following a failure during its most recent MOT test on 30 July 2026. While the vehicle passed the inspection, the transition from a clean record in August 2025 to a failure in July 2026 indicates a recent decline in the condition of consumables. The failure was specifically linked to ineffective windscreen wipers on both the nearside and offside fronts, alongside insufficient washer fluid, which necessitated remedial action to achieve a pass. The recorded mileage of 47,569 miles over approximately four years represents an average annual accumulation of roughly 11,892 miles. This usage pattern is consistent with typical UK driving cycles and suggests a steady rate of wear across mechanical components rather than extreme high-speed motorway use or excessively low-mileage periods of inactivity. This level of mileage means that components such as suspension bushes, brake pads, and wiper assemblies are reaching mid-life stages where wear becomes more apparent in official testing. Prospective buyers should pay close attention to the ongoing advisories regarding the nearside front shock absorber, which is noted for having a light misting of oil. This indicates a potential early-stage seal failure. During a test drive, you should listen for any knocking or clunking sounds when driving over uneven surfaces or speed bumps, and monitor the vehicle for any excessive bouncing or a lack of controlled damping, which would suggest the shock absorber is losing its effectiveness. The advisory regarding the offside rear tyre showing signs of damage, cracking, or perishing should also be addressed. You should inspect the sidewall of the tyre for any deep fissures or bulges and check the tread depth across the entire width of the tyre. Additionally, ensure the windscreen wiper blades are replaced with high-quality units to prevent a recurrence of the recent failure, and verify that the washer system operates with sufficient pressure to clear the screen effectively.