1990 Mercedes 190E Auto 2.0L Petrol · H59 GPB

The vehicle’s most recent MOT test on 2025-07-11 confirms it passed with no defects recorded at 113,862 miles, though it failed the preceding test just ten days earlier at 116,573 miles without any specific faults noted. This abrupt failure followed a similar pattern in 2024, where it passed on 2024-06-27 at 108,125 miles before failing the following test at 108,098 miles—just three days earlier and with no recorded issues. While the vehicle has not failed for defects, the repeated failures without explanation suggest either administrative oversights, last-minute adjustments, or a lack of transparency in the testing process. The absence of advisories or recurring fault codes across all tests implies no obvious mechanical trend, but the irregular pass/fail pattern warrants scrutiny of whether critical components were overlooked or if the vehicle was driven between tests to reset minor issues. The recorded mileage of 113,862 miles over approximately 36 years equates to an average of around 3,163 miles per year, which is unusually low for a vehicle of this age. The gap between the 2023 and 2024 tests spans 13 months, during which the mileage only increased by roughly 9,000 miles, suggesting prolonged periods of inactivity. The sudden jump from 108,098 to 116,573 miles between the 2024 failures—covering just 8,475 miles in under two months—may indicate sporadic use rather than consistent driving. Such low mileage can mask deeper wear issues, particularly in components like suspension bushes, coil springs, and brake calipers, which degrade over time regardless of mileage. Given the lack of specific defect records, a buyer should prioritise an independent inspection of the suspension geometry, particularly the rear bushings and coil springs, which are prone to fatigue in a vehicle of this vintage. The binding brake calipers or discs, if present, would have been flagged in previous tests, but the repeated failures without explanation raise suspicion of potential brake system inconsistencies. Structural corrosion, especially around the wheel arches, subframe, and exhaust system, should be thoroughly checked, as rust can compromise structural integrity without always appearing in MOT records. Additionally, the exhaust emissions system—if equipped with catalytic converters or oxygen sensors—may require verification, as older Mercedes models are susceptible to sensor failures that can evade basic MOT scrutiny.