2021 Ford Kuga ST-Line Edition Ecoblue 1.5L Heavy oil · KB07 SMB

The most recent MOT certificate from September 2025 indicates a successful pass with no recorded defects or advisories. This suggests that the vehicle was in a compliant state regarding its structural integrity, lighting, braking, and emissions at the time of testing. Based on the available data, the maintenance trend appears stable, as there is no evidence of recurring failures or a history of neglected components that typically precede an MOT failure. The recorded mileage of 59,005 miles over a five-year period equates to an annual average of approximately 11,800 miles. This usage profile is consistent with typical UK driving patterns and represents a healthy balance for a diesel engine. It suggests the vehicle has been used enough to prevent the accumulation of moisture and carbon deposits within the exhaust system and diesel particulate filter, yet it has not been subjected to the excessive wear on suspension bushes, coil springs, and drivetrain components associated with high-mileage or heavy-duty use. As the MOT history is clean, your physical inspection should focus on age-related degradation and time-based maintenance. Closely inspect the tyres for any signs of perishing or sidewall cracking, which can occur as rubber ages regardless of tread depth. You should also check for uneven wear across the tyre tread, which may indicate issues with wheel alignment or worn suspension components. Given the vehicle's age, verify the service history to ensure that essential fluids, such as engine oil and brake fluid, have been changed according to the manufacturer's time intervals rather than solely on mileage. During the test drive, pay close attention to the tactile and auditory feedback from the vehicle. Listen for any clunks or knocks from the suspension when driving over bumps, which could signal worn bushes or dampers. Test the brakes thoroughly for any shuddering through the pedal or pulling to one side, which might indicate warped discs or binding calipers. Finally, ensure the engine runs smoothly and check for any signs of fluid weeping around the engine bay, as seals and gaskets can begin to degrade after five years of service.