2006 Ford Fiesta 1.4L Petrol · KF56 AEN

The 2006 Ford Fiesta demonstrates stable roadworthiness, with all five consecutive MOT tests from 2021 to 2025 resulting in passing scores and no recorded defects. The most recent test on 2025-07-14 at 98,045 miles confirms consistent compliance, indicating no emerging mechanical or structural issues. Annual testing intervals and uniform mileage accumulation suggest a predictable maintenance schedule, with no evidence of recurring faults or escalating risks. The absence of advisories or failures across this period implies the vehicle has been well-kept, though low mileage over two decades warrants scrutiny of components prone to inactivity-related degradation. The vehicle’s mileage of 98,045 miles over 20 years equates to approximately 4,902 miles annually, significantly below average for its age. This pattern suggests either infrequent use or prolonged periods of inactivity, which can accelerate wear on systems requiring regular operation, such as the battery, belts, and suspension. Notably, the 2021-2025 tests show minimal mileage fluctuations, with annual increases of 1,377 to 6,570 miles, reflecting steady but light usage. The lack of gaps in testing aligns with this trend, confirming ongoing attention to regulatory compliance. However, the low annual average raises questions about potential dry rot in rubber components or seized moving parts, which may not surface in standard MOT checks. A buyer should prioritise inspecting the suspension system for hardened bushes or coil springs, as low mileage can lead to stiffness or failure under load. The exhaust system merits close examination for corrosion, a common issue in older vehicles with limited operation. Electrical components, including the battery and starter motor, should also be tested, as inactivity may have caused degradation. While the MOT history shows no immediate concerns, the vehicle’s usage pattern necessitates a thorough pre-purchase check to confirm that hidden wear has not developed in areas not assessed during standard inspections.