2010 Alfa Romeo Mito 1.4L Petrol · LP59 OMH

The vehicle presents a concerning roadworthiness profile with a maintenance trend that appears reactive rather than proactive. While the car passed its most recent test in July 2025 at 112,818 miles, this followed a failure just six days prior at 112,801 miles. That failure highlighted significant exhaust emissions issues and an exhaust leak, indicating the engine management system or exhaust integrity is struggling. The recurring nature of emissions-related faults suggests that the owner only addresses mechanical defects when forced by an MOT failure. At 112,818 miles over 16 years, the Alfa Romeo averages approximately 7,050 miles per year, which is consistent with low-use urban driving. However, the data shows a surge in usage with nearly 23,000 miles covered between April 2023 and July 2024, and another 13,000 miles between July 2024 and July 2025. This recent increase in mileage places higher stress on wear components and suspension elements which have already shown signs of neglect in the record. A buyer must conduct a thorough physical inspection of the braking and suspension systems. The history shows a pattern of neglected components, including a fractured nearside coil spring and a rough offside rear wheel bearing noted in early 2023. The front brake discs were flagged as pitted and scored in 2023, and the handbrake was reported as weak in 2024. You should check for binding calipers and uneven tyre wear, as the tester previously noted tyres being worn on the edge or below limits. The exhaust system remains a primary area of concern. Multiple failures regarding Lambda readings and leaks between 2023 and 2025 indicate a potentially failing oxygen sensor or a persistent exhaust manifold leak. A technician should inspect the entire exhaust length for corrosion and verify that the catalytic converter is operating efficiently. Given the history of allowing wipers and tyres to reach legal limit status before replacement, the vehicle likely requires immediate investment in basic consumables to ensure safety.