2019 Mclaren GT V8 S-A 4.0L Petrol · NE19 TON

The vehicle’s most recent MOT test on 2025-11-06 at 20,019 miles confirms a clean pass with no defects, indicating current roadworthiness. The trend over the past three tests (2024, 2025) shows consistent compliance, though the single failure in October 2023—due to rear tyre tread depth—was an isolated incident resolved promptly. With the latest test just six months ago, the vehicle meets all current legal requirements without outstanding advisories. However, the absence of any advisories in prior tests suggests either meticulous maintenance or a vehicle designed to tolerate low-mileage wear without premature degradation. The recorded mileage of 20,019 miles over seven years equates to approximately 2,860 miles annually, which is unusually low for a high-performance supercar of this type. The gap between the 2023 failure (16,149 miles) and the subsequent 2022 test (15,252 miles) indicates a 900-mile period without testing, though this was rectified within days. The 2024 and 2025 tests occurred at 17,391 and 20,019 miles respectively, showing a steady but slow accumulation of miles, which could imply limited use or extended periods of storage. Such low mileage may reduce wear on high-stress components like suspension bushes or brake calipers, but it also raises questions about fluid changes, tyre rotation, and potential long-term degradation of seals or carbon components. Given the isolated tyre tread failure in 2023, a buyer should prioritise inspecting the current tread depth and condition of all four tyres, ensuring no uneven wear or embedded debris. The absence of advisories in recent tests suggests no recurring issues with suspension geometry or binding calipers, but a thorough check of rear wheel bearings and bushings—common points of wear in low-mileage vehicles—is warranted. The vehicle’s age and low mileage also necessitate scrutiny of fluid levels (brake, clutch, differential, and coolant) and their condition, as prolonged storage can lead to degradation or contamination. Finally, the carbon-ceramic brake system, if fitted, should be examined for surface integrity and uniform pad wear, as these components are less forgiving to neglect.