2022 MG 5 Electric · OU72 BWN

The most recent MOT test, completed on 8 October 2025, resulted in a pass with no defects or advisories recorded. Based on this recent data point, the vehicle's maintenance trend appears stable and meets the necessary regulatory standards for roadworthiness. The lack of recorded advisories suggests that all critical safety components, including lighting, steering, and braking systems, were functioning correctly at the time of the inspection. The recorded mileage of 11,736 miles for a four-year-old vehicle indicates an exceptionally low usage rate of approximately 2,934 miles per annum. While this suggests minimal wear on the engine, gearbox, and suspension components, such low mileage often implies the vehicle has been subject to long periods of standing. This usage profile carries specific mechanical implications, as components that are not regularly cycled can suffer from different types of degradation than those subjected to high-frequency driving. Given the clean MOT history and low mileage, your inspection should focus on age-related degradation rather than wear-based failure. Closely examine the tyres for signs of perishing, sidewall cracking, or dry rot, as rubber degrades over time even if the tread depth remains high. During the test drive, pay attention to the braking system; listen for any clicking or grinding that might indicate binding calipers or seized components from lack of use, and feel for any shuddering through the pedal which could signal unevenly corroded brake discs. You should also investigate the health of the 12V battery and the condition of the vehicle's fluids. Low-use vehicles are susceptible to battery discharge and loss of charge capacity, so ensure the electrical systems operate without hesitation. Crucially, verify the service book to confirm that maintenance has been carried out on a calendar-based schedule. Fluids such as engine oil and brake fluid can degrade chemically over time regardless of mileage, so ensure that time-based service intervals have been respected to prevent internal component contamination or reduced hydraulic efficiency.