2022 Polestar 2 Plus EV AWD Electricity · OY72 UUO

High annual mileage and a recent failure regarding tyre integrity define the mechanical profile of this vehicle. The most recent MOT inspection on 03 June 2026 resulted in an initial failure due to a dangerous defect where the offside front inner tyre had exposed ply or cords, followed by a pass once the issue was rectified. This failure indicates that the tyre had reached a critical level of wear, specifically on the inner edge, which can often be a symptom of alignment issues or uneven load distribution. The vehicle has covered 70,377 miles in approximately four years, representing an average annual usage of roughly 17,594 miles. This is a high rate of accumulation for a relatively young electric vehicle. Mechanically, this level of consistent, high-frequency use means that consumable components such as suspension bushes, steering linkages, and braking systems will have experienced significantly more cycles of wear and tear than a typical low-mileage vehicle of the same age. The rapid mileage accumulation necessitates a closer inspection of all wear-related items. Given the specific failure of the offside front inner tyre with exposed cords, a test drive should focus heavily on steering and suspension geometry. You should check for any pulling to one side during straight-line driving or a wandering sensation through the steering wheel, which could indicate that the uneven tyre wear was caused by incorrect camber or toe settings. Listen closely for any rhythmic thumping or vibration through the floorpan or steering column that might suggest further tyre deformation or underlying suspension component wear. Furthermore, the high mileage warrants a thorough check of the suspension system for any signs of premature degradation. During the test drive, pay attention to any knocks, clunks, or creaks when navigating uneven road surfaces or speed bumps, as these are common indicators of worn bushes or ball joints in high-mileage vehicles. While the MOT record is currently clear of other defects, the recent tyre failure highlights the importance of verifying that the wheel alignment is within manufacturer specifications to prevent rapid, uneven wear on the remaining tyres.