1997 Vauxhall Vectra 2.0L Petrol · P606 ETT

The Vectra B's steel brake pipes run along the underside and past the rear axle, exactly where winter salt collects, and GetCarWise's MOT analysis shows this model failing brake pipe inspections at dozens of times the national average, with a full replacement quoted at £200-£800. BreakerYard's Vectra fault guide covers the parking half of the same corrosion story: a handbrake that has to be pulled very high up its ratchet, or that no longer holds the car, means the cables are rusted inside their outer conduits. Both faults begin as an MOT advisory and end as a soft pedal, a weeping joint or a car that rolls on a hill.

The Vectra B's front lower wishbones and rear trailing arms are a documented MOT weak point: GetCarWise's analysis of DVSA failure data puts suspension defects for this model at many times the fleet average, with damper failures and perished ball-joint dust covers listed alongside them. BreakerYard's Vectra guide describes the symptom owners recognise - a knock over speed bumps or broken surfaces caused by bushes that have cracked. Once corrosion attacks the mounting points the geometry changes, so the car scuffs tyres, wanders on motorway camber and drags itself through the test.

A persistent engine management warning lamp on the Vectra B is predominantly caused by failing camshaft position or crankshaft speed sensors on the 1.6, 1.8 (X18XE/Z18XE) and 2.0 (X20XEV) 16V Ecotec petrol engines. BreakerYard identifies the camshaft and crankshaft sensors as the primary culprits behind the engine management light on the Vectra B, requiring diagnostic interrogation and sensor replacement. RAC Drive also warns used Vectra buyers about intermittent engine running faults and warns that dashboard warning lights must extinguish after starting. When the camshaft sensor fails, the Siemens Simtec engine management ECU activates a 4,500 rpm rev-limiter safety cut-off, causing flat acceleration and rough idling.