2012 Audi A4 2.0L Diesel · PJ12 ACO

The 2012 Audi A4 has maintained a clean MOT history with no defects recorded across the last five tests, most recently passing on 20 May 2025 at 161,440 miles. This suggests a stable roadworthiness trend with no recurring mechanical issues. The absence of advisories or failings in the most recent tests indicates the vehicle has not experienced any significant failures in braking, suspension, exhaust emissions, or structural integrity during the past year. However, the 2023 record shows a duplicate entry—one pass and one fail at the same mileage—likely an administrative error rather than a mechanical anomaly, as no defects were logged. The mileage progression of approximately 11,500 miles per year aligns with typical usage for a vehicle of this age. There are no abrupt jumps or prolonged gaps in mileage that would raise concern about neglect or excessive wear. The most recent MOT was conducted just over two years ago, which is within the standard three-year cycle but nearing the point where another test will be required. Given the vehicle’s age and mileage, a pre-purchase inspection should verify the integrity of high-wear components that are not always captured in a standard MOT, such as the condition of suspension bushes, coil springs, and rear wheel bearings. Given the lack of recorded defects, the primary focus for a buyer should be the suspension system, particularly the alignment and wear of bushes and struts, which are prone to deterioration over 14 years and 160,000 miles. The braking system, while not failed in MOTs, should be inspected for uneven pad wear, binding calipers, or corrosion on the rear discs, as Audi models of this era can develop subtle issues in the rear brake hardware. Structural corrosion, particularly around wheel arches, sills, and the subframe, should also be examined, as this is a common failure point for vehicles of this age exposed to UK road conditions. Finally, the exhaust system should be checked for leaks or excessive rust, as catalytic converter failures or cracked manifolds are not always detected in a basic MOT.