2021 Audi A3 S Line 35 Tfsi Mhev S-A 1.5L Petrol · SW21 GGK

The vehicle most recently passed its MOT on 24 April 2026, although the appearance of multiple tyre advisories suggests a downward trend in the condition of wear-and-tear components. While the vehicle has maintained a consistent pass rate, the transition from a clean record in 2025 to multiple tyre concerns in 2026 indicates that consumables are reaching the end of their service life and may have been overlooked during routine maintenance. With a recorded mileage of 40,608 miles over approximately five years, the vehicle has averaged roughly 8,122 miles per annum. This usage profile is considered typical for this class of vehicle, suggesting a balanced mix of urban and motorway driving. There are no indications of excessive wear from high mileage or the degradation associated with prolonged periods of standing, meaning the drivetrain and suspension components should be in a condition consistent with moderate, regular use. Prospective buyers should pay close attention to the tyre wear noted in the latest inspection. The specific mention of inner edge wear on both front tyres is a classic symptom of incorrect wheel alignment, likely involving excessive negative camber or toe-out. During a test drive, listen for increased road noise and check if the vehicle drifts or pulls to one side. It is highly probable that a full four-wheel alignment and a complete set of replacement tyres will be required shortly to ensure safety and prevent premature wear of the new rubber. Additionally, the 2024 advisories regarding pitted and scored front brake discs warrant investigation. While not mentioned in the most recent test, the buyer should feel for any shuddering or pulsing through the brake pedal during deceleration, which could indicate surface irregularity or warping. Given the mild hybrid nature of the drivetrain, verify the health of the 12V battery and the seamless operation of the start-stop system. Finally, ensure the service history confirms that oil and filter changes have been performed according to the manufacturer's calendar intervals to ensure the long-term integrity of the engine.