2003 MG TF 1.8L Petrol · T60 VVC

This MG TF has maintained a consistent roadworthiness record over the past four MOT cycles, with the most recent test on 11 October 2025—just under ten months ago—showing no defects. The vehicle’s history demonstrates a stable pattern of compliance, with every inspection passing without advisories or failures. While the absence of recorded issues suggests the tester did not identify any major mechanical or structural concerns during those tests, the lack of advisories also means no wear or faults were flagged for attention between inspections. Given the vehicle’s age and mileage, this implies either diligent maintenance by previous owners or that critical components have yet to show visible degradation. The recorded mileage of 66,448 miles, averaging roughly 2,889 miles per year, is unusually low for a vehicle of this age. The most significant gap in testing occurs between the May 2022 and October 2023 MOTs—a span of nearly 17 months with no documented mileage progression. This suggests the car may have been stationary for extended periods, which could accelerate issues like suspension corrosion, tyre degradation, or battery deterioration. The subsequent mileage increments appear modest, reinforcing the likelihood of infrequent use rather than heavy daily driving. A buyer should prioritise an in-person inspection of the suspension components, particularly the coil springs and bushes, as prolonged inactivity can exacerbate wear or corrosion. The brakes, while not flagged in MOTs, warrant scrutiny for uneven wear or binding calipers, especially if the vehicle has spent time unused. Structural integrity is another concern—check for rust penetration in the chassis, sills, and wheel arches, as static corrosion can compromise load-bearing areas. Finally, the battery and electrical systems should be tested, as deep discharge from non-use can lead to parasitic drain or failure. Given the clean MOT history, no major repairs are immediately evident, but these areas demand thorough examination to confirm long-term reliability.