1999 Nissan Almera 1.4L Petrol · V310 ABW

DVSA campaign R/2004/089 names Almera cars built between 1 July 1999 and 1 December 2002 - 3,001 in the UK - where the sprocket bolt at the rear of the camshaft and the timing chain tensioner can be defective. The stated consequence is that the chain jams, the engine stalls and may fail to start again, which on a chain-driven engine normally means bent valves and a scrap engine or a costly rebuild. Late N15 cars fall into the earliest part of that build window, so a 1999 or 2000 Almera with a rattling cold start and no paperwork is the risk case, and a repair on a car worth £800 is rarely economic.

The Almeras reliability was its virtue and its corrosion its vice: CarPeeps DfT and MOT analysis counts only about 8,600 licensed at mid-2026 and records a 55.7% initial MOT pass rate in 2025, 16.6 points under the UK average, with the models remaining cars mostly early-2000s examples. The RACs used guide adds the other half of the story: not much goes wrong, but parts are not cheap, quoting around £135 for a clutch assembly, £390 for a full exhaust, £325 for an alternator and £185 for a starter motor. That combination - a rusting, low-value car with mid-range parts prices - means structural rot is what ends these, and cheap repairs are rarely worth doing.

On 1.4 GA14DE and 1.6 GA16DE 16v petrol engines, the optical distributor sensor or crank angle position sensor suffers from internal thermal degradation. As engine bay temperatures rise during traffic driving, internal electronic pick-up coils fail, cutting the ignition signal to the ECU. The engine cuts out without warning and will crank vigorously without firing until allowed to cool down for 20 to 30 minutes, mimicking the symptoms of late-model recall R/2001/154.