2015 Jeep Renegade 2.0L Diesel · WM15 PZE

A remarkably clean MOT history defines this 2015 Jeep Renegade; across eight consecutive annual tests the vehicle has passed without a single failure, the most recent assessment on 26 May 2026 confirming roadworthiness. The only recorded items are two non‑fatal advisories – a near‑limit tread depth on the nearside rear tyre in 2022 and the removal of items that could obstruct the driver’s view in 2021 – indicating that structural and safety‑critical systems have remained within acceptable limits throughout the period. With 32,147 miles logged over roughly eleven years the average annual accumulation is just under 3,000 miles, considerably below the typical UK usage rate for a vehicle of this age. The consistent yearly MOT cadence, with no gaps between 2019 and 2026, suggests the odometer reading reflects genuine low‑kilometre operation rather than undocumented mileage spikes. Mechanically this low exposure generally translates to reduced wear on wear‑items such as brake pads, clutch plates and suspension bushings, but it also raises the possibility of prolonged stationary periods that can affect rubber components and fluid seals, so those areas merit visual scrutiny. The rear‑tyre advisory from 2022 warrants a focused tyre inspection. Verify that the tread depth on the nearside rear wheel exceeds the legal 1.6 mm minimum and that the wear pattern is even across the tread width; uneven wear could point to mis‑aligned rear suspension or worn rear‑axle components. While on the road, feel for any vibration or pulsation through the steering column that may indicate a developing tyre defect, and listen for thumping noises that could signal a loose wheel nut or deteriorated rim. Replacing the tyre with a matching size and ensuring proper balancing will eliminate the advisory and restore full compliance. The 2021 advisory concerning items removed from the driver’s view suggests that something – perhaps a windshield wiper blade, interior trim or a rear‑view mirror – was absent at the time of testing. Confirm that all glazing, wiper mechanisms and mirrors are correctly fitted, securely mounted and provide an unobstructed line of sight. During a test drive, check for blind‑spot visibility, ensure the wipers clear the windscreen without streaking, and verify that any interior fittings do not impede the driver’s forward view, especially at higher speeds. Addressing these points will remove the advisory and confirm that the vehicle meets the visual safety standards required for road use.