2009 Audi A4 2.0L Diesel · YN59 JJE

The vehicle is currently roadworthy but the maintenance history indicates a reactive rather than proactive ownership pattern. While the most recent test in July 2025 at 106,069 miles resulted in a pass, it followed a failure just two miles prior. The trend shows that the owner only addresses defects once they reach a legal failure threshold. The July 2025 failure highlighted multiple critical issues including worn nearside rear brake pads, an illegal offside front tyre, and worn suspension components. At 106,069 miles, this 17-year-old Audi averages approximately 6,200 miles per year, which is consistent with low-intensity usage. The data shows a steady increase in mileage intervals, with roughly 11,000 miles covered between November 2023 and December 2024, and another 10,000 miles between December 2024 and July 2025. This consistent usage often masks the age-related degradation of rubber components and hardware despite the low annual mileage. A buyer must closely inspect the front suspension, as the nearside upper suspension arm bushes have been flagged as worn since at least 2023 and remained present through the 2025 pass. The recurring nature of this fault suggests they are nearing replacement, which will eventually affect handling and tyre wear. The braking system also shows a history of neglect, with thin pads being noted in 2023 and 2024 before finally failing in the latest test. The offside rear brake disc was noted as pitted and scored, indicating the metal surface is deteriorating and likely requires replacement. The tyres represent another consistent point of failure, with multiple entries for being below legal limits or worn unevenly across the last three years. A prospective buyer should verify the current tread depth on all four tyres and check for alignment issues to ensure the suspension is not causing premature tyre failure. Given the age of the vehicle, a physical inspection for structural corrosion on the chassis points is also advisable, though the MOT record focuses primarily on mechanical wear and safety items.