IsItAGoodCar
Reliability Guide

Common Problems with the
2000 MG Rover Rover 45 / MG ZS

We've identified 4 known issues that can affect the 2000 MG Rover Rover 45 / MG ZS. 1 of these are serious faults that could be expensive to repair.

4
Known Issues
1
Serious
2
Moderate
1
Minor

All Known Issues

K-Series Head Gasket Failure (1.4/1.6/1.8)

SeriousEngine

The K-Series petrol engines are prone to head gasket failure due to plastic dowels and low coolant capacity. The 2.0 V6 also uses K-Series architecture and shares similar cooling weaknesses.

Est. Repair Cost: £500–£800
Warning Signs:

Overheating, Oil/coolant mixing, Loss of heater performance

What to Inspect:
  • Check the oil filler cap and expansion tank for contamination
Verified by IsItAGoodCar Research Team

VIS Motor Failure (V6)

ModerateEngine

Variable intake motors fail, leading to reduced performance.

Est. Repair Cost: £150–£300
Warning Signs:

Flat spots in acceleration, Rattling manifold

Verified by IsItAGoodCar Research Team

Water Ingress (Bulkhead Seam Failure)

ModerateBodywork & Rust

The seam sealer on the bulkhead can crack with age, allowing water into the front passenger footwell. This can affect electrical components under the carpet.

Est. Repair Cost: £100–£300
Warning Signs:

Wet front passenger carpet, Damp smell in cabin, Electrical faults from water-damaged wiring

What to Inspect:
  • Lift the front passenger carpet and inspect the bulkhead seams
  • Check for water staining under the carpet
Verified by IsItAGoodCar Research Team

Sagging Headlining

MinorInterior & Trim

The glue holding the headlining fabric to the roof board fails, causing the fabric to hang down and obstruct the driver's view.

Est. Repair Cost: £100–£250
Warning Signs:

Roof fabric hanging down, Obstructed rear view

What to Inspect:
  • Look at the ceiling for signs of sagging or temporary fixes like pins
Verified by IsItAGoodCar Research Team

Buying Tips for 2000 MG Rover Rover 45 / MG ZS

  • The K-Series head gasket is the primary concern; look for "mayonnaise" under the oil cap or a sweet smell of coolant.
  • Check the KV6 (in the ZS 180) for timing belt replacement history; it is a complex, expensive job requiring specialist tools.
  • Inspect the bodywork for rust, particularly around the rear wheel arches and the bottom of the doors.
  • Test the heater blower; if it only works on setting 4, the resistor pack has failed.
  • Listen for knocks from the front suspension, as the sharp handling of the ZS accelerates wear on bushes and joints.
  • Check the condition of the interior fabric or leather, as the seat bolsters wear very quickly.