2019 ISUZU D-MAX1.9L Diesel

The vehicle’s most recent MOT test on 2026-01-22 shows it passed without defects, though it failed the preceding test just seven days earlier on 2026-01-15—an unusual but not unprecedented anomaly in the DVSA system. The broader trend over the past two years remains stable, with no recurring advisories or defects beyond the two identical failures at 98,872 miles in February 2025. Both failures were recorded without specifying issues, which suggests either a minor administrative oversight or a temporary technical hiccup during testing. That said, the lack of defects in all other tests indicates the vehicle has not been subjected to repeated or escalating mechanical failures. The most recent pass, just six months ago, aligns with the typical MOT renewal cycle, though the rapid back-to-back tests in January 2026 warrant scrutiny of whether the vehicle was driven between them. The recorded mileage of 100,054 miles over approximately seven years equates to an average of 14,293 miles annually, which is significantly higher than the UK average for a vehicle of this age. This suggests either consistent heavy use or prolonged periods of inactivity followed by rapid mileage accumulation. Notably, there is a 13,000-mile gap between the February 2024 test at 85,739 miles and the February 2025 test at 98,872 miles, implying the vehicle may have been stored or driven infrequently during that period. The subsequent 1,182 miles logged between the two 2025 tests—both failures—further complicates the pattern, as it’s unusual to accumulate such a small distance in such a short timeframe without mechanical intervention. This irregularity could indicate either a test error or a vehicle that was moved briefly before retesting. Given the sparse defect history, the primary focus for an in-person inspection should centre on components typically affected by high mileage and inconsistent usage. The suspension system—particularly coil springs, bushes, and shock absorbers—should be examined for uneven wear, fluid leaks, or binding, as these are common points of failure in vehicles with this mileage. Brake discs and calipers, especially if the vehicle has been driven hard in recent months, may show signs of uneven wear or binding, though the lack of advisories in prior tests suggests no severe brake issues. Structural integrity, including underbody corrosion and wheel bearing condition, must also be assessed, as prolonged storage can accelerate rust formation. Finally, the engine bay should be checked for oil leaks or degraded hoses, as high mileage often correlates with consumable wear in these areas. The absence of advisories does not guarantee these components are flawless, but it does indicate they have not yet failed to MOT standards.