2010 Tesla Roadster Electric · FJ60 OZO

The first-generation Roadster lacks the deep-sleep low-power hibernation states engineered into modern electric vehicles. Continuous parasitic current draw from the Vehicle Management System (VMS) and auxiliary cooling pumps drains the 53 kWh battery pack if left unplugged. If state-of-charge drops to 0%, individual lithium-ion cells drop below critical voltage thresholds, causing irreversible internal chemical breakdown, sheet undervoltage lockouts, and refusal of the onboard charger to engage. Recovering a bricked pack requires high-voltage DC revival by specialists or a full battery rebuild.

The Power Electronics Module (PEM) converts high-voltage DC battery power into variable-frequency three-phase AC power for the induction motor. Over prolonged exposure to heat cycles, road grime sucked through cooling ducts, and component ageing, the PEM's internal IGBT power switching transistors, DC bus capacitors, and gate drive boards degrade. This causes the car to throw drive inverter faults, enter severe limp-home mode with reduced power, or completely refuse to drive. Specialist bench rebuilding with upgraded cooling blowers and modern silicon components is necessary.

Built upon the lightweight Lotus Elise extruded aluminium chassis architecture, the Tesla Roadster carries a substantial weight penalty due to its 450 kg battery assembly, bringing total kerb weight to nearly 1,240–1,300 kg. This extra mass accelerates wear on the front and rear upper and lower ball joints, anti-roll bar drop links, and rubber wishbone bushings when driven across demanding UK road surfaces. Worn joints result in clunks over road imperfections, vagueness in steering precision, uneven tyre wear, and MOT failure for excessive suspension movement.