2021 Ford Tourneo Custom 2.0L Diesel · YS21 UCM

A pattern of recurring tyre-related advisories and visibility-related failures defines the recent MOT history of this Ford Tourneo Custom, though the most recent test on 04 February 2026 shows a clean pass with no defects recorded. The vehicle experienced a significant failure in August 2024 involving windscreen washer jets, wiper effectiveness, and headlamp aim, followed by a period of advisories concerning tyre damage and tyre pressure monitoring system issues in 2025. While the latest result suggests these specific issues have been addressed, the intermittent presence of nails in the tyres and concerns regarding tyre condition and lighting components indicate a history of minor consumable wear and component faults. The vehicle has covered 58,566 miles over approximately five years, representing an average annual usage of roughly 11,713 miles. This mileage accumulation is consistent with typical usage for a vehicle of this age and suggests a steady operational life rather than periods of prolonged inactivity or excessive high-speed motorway running. From a mechanical perspective, this level of usage means that while the drivetrain and major structural components should not be excessively worn, consumables such as brake pads, discs, and suspension bushes will likely be approaching the middle or end of their service life, requiring careful inspection. Prospective buyers should pay close attention to the tyre condition and the tyre pressure monitoring system, given the advisories recorded in 2024 and 2025. During a test drive, it is essential to inspect all four tyres for uneven wear patterns, sidewall cracking, or embedded objects that could lead to further punctures. The presence of a TPMS advisory suggests that the sensors or the system itself may require investigation; listen for any audible leaks and check the dashboard for any recurring warning lights. Additionally, verify that the high-level stop lamp and all other exterior lighting are functioning correctly to ensure the issues noted in the 2025 test have been fully rectified. The previous failure regarding windscreen wipers and washer jets necessitates a functional check of the entire visibility system. Ensure that the wiper blades clear the glass smoothly without streaking or juddering and that the washer jets provide a strong, directed spray across the full width of the windscreen. Any hesitation in the wiper motor or a weak spray from the jets could indicate that the previous major defects have not been comprehensively resolved. Finally, confirm that the headlamp aim is correct by checking for any excessive glare or uneven light distribution when driving in low-light conditions.