2020 Maserati Levante Granlusso V6 Auto 3.0L Petrol · 1 AGL

A consistent record of clean roadworthiness defines this vehicle, with the most recent test on 12 June 2026 returning no defects. While the 2024 inspection flagged an advisory regarding offside front tyre wear on the inner edge, the subsequent two years of testing show no recurring issues with tyre condition, suspension geometry, or braking components. This pattern suggests a stable mechanical history where previous minor wear items have been addressed, resulting in the defect-free outcomes seen in both 2025 and 2026. The vehicle exhibits a low-usage profile, having covered 33,677 miles over approximately six years, which equates to an average annual accumulation of roughly 5,613 miles. This level of mileage is significantly lower than the typical UK average for a vehicle of this age and class. Mechanically, such low annual mileage can imply less frequent wear on drivetrain components and engine internals, though it also necessitates closer inspection of rubber components and seals that may be subject to age-related degradation rather than mileage-related wear. Given the specific advisory recorded in 2024 regarding the offside front tyre being worn close to the legal limit on the inner edge, a prospective buyer should pay close attention to the front suspension and steering alignment during a test drive. Uneven tyre wear on the inner edge often points to issues with camber angles or worn suspension bushes. During the drive, listen for any irregular knocking or clunking sounds when navigating uneven surfaces or speed bumps, and check for any pulling to one side when the steering wheel is released on a level road, which could indicate a misalignment or a failing component in the steering rack or wishbone assemblies. Beyond the tyre wear, the absence of any recorded structural corrosion, brake pipe degradation, or exhaust emissions issues in the MOT history provides a baseline for the vehicle's current state. However, because the mileage is relatively low, it is prudent to inspect the condition of the brake discs for surface pitting or uneven corrosion, which can occur when a vehicle is not driven frequently enough to keep the components clean. Ensure the brake pedal feels firm and consistent, without any pulsation or judder that might suggest uneven disc wear or binding calipers.