2021 Harley-Davidson XL 1.2L Petrol · AE70 EVL

The most recent MOT, conducted on 12 September 2023 at 2,145 miles, resulted in a pass, but the record reveals a concerning pattern of neglect rather than diligent upkeep. The same test session produced both a failure and a pass, indicating the vehicle was submitted with a missing rear reflector and a noisy exhaust, which were rectified on the day. The maintenance trend is stable but superficial, pointing to a reactive approach where only the minimum was done to secure a pass certificate rather than proactive mechanical care. The mileage data tells a clear story of extremely low use. The vehicle covered just 686 miles between the November 2022 test at 1,459 miles and the September 2023 test at 2,145 miles. As of today, 18 June 2026, the recorded mileage remains frozen at 2,145 miles, meaning this motorcycle has not been presented for an MOT in nearly three years. For a machine of this age, such prolonged inactivity raises immediate questions about its storage conditions and the state of perishable components. A buyer should treat this vehicle as a long-term static exhibit rather than a regularly serviced machine. The offside exhaust defect flagged in September 2023, described as noisy, warrants close inspection for internal baffle degradation or loose fixings, which can worsen with thermal cycling even when standing. The missing rear reflector on the same date suggests impact damage or careless removal, so check the surrounding rear cowl and light cluster for cracks or poor alignment. Beyond the recorded defects, the critical inspection points are the fuel system, tyres, and brakes. Petrol left to degrade in a standing tank will have varnished the carburettor or injector and contaminated the fuel lines. Both tyres, even with full tread, are likely perished from age and will need replacement. Brake discs will almost certainly have surface corrosion from prolonged standing, and the caliper pistons may be seized. Drain the old fuel, remove and clean the brake calipers, and replace all rubber hoses before attempting to ride the machine.