2016 Audi Q3 SE TDI Quattro 2.0L Heavy oil · BR11 BAZ

The 2016 Audi Q3 SE TDI Quattro has passed its most recent MOT on 2026-02-11 at 90,908 miles, with no defects recorded. This represents a stable roadworthiness trend over the past five months, as no prior MOT failures or advisories are visible in the available record. The absence of recurring issues suggests the vehicle has either received consistent maintenance or that critical components have not yet reached failure thresholds. However, the sparse MOT history—limited to a single test in the last year—means there is no evidence of long-term reliability patterns, leaving some uncertainty about how well the vehicle has been cared for over its lifetime. The recorded mileage of 90,908 miles over approximately ten years equates to an average of 9,091 miles per annum, which is typical for a vehicle of this age. There are no gaps in the record to suggest prolonged periods of disuse, nor is there evidence of unusually rapid mileage accumulation that might indicate aggressive driving or neglect. While this average suggests moderate usage, the lack of MOT tests before February 2026 means there is no historical data to confirm whether earlier owners maintained the vehicle diligently or if any critical components were replaced or repaired between tests. Given the limited MOT history, a prospective buyer should prioritise an independent inspection of high-wear areas that are not directly tested during an MOT. The suspension—particularly coil springs, bushes, and dampers—should be examined for uneven wear or leaks, as these are not routinely checked in an MOT but can significantly affect handling and safety. The brake system, including calipers, pads, and discs, warrants close scrutiny, especially if the vehicle has been driven hard or exposed to heavy loads, as binding or uneven wear could develop without MOT detection. Additionally, the drivetrain, including the turbocharger and intercooler in the TDI engine, should be inspected for oil leaks or excessive carbon buildup, as these are common failure points in diesel units of this age. Finally, a thorough check for corrosion—particularly around wheel arches, sills, and the subframe—is essential, as this can compromise structural integrity over time.