2018 Audi Q2 1.0L Petrol · DS10 ABS

A consistent track record of roadworthiness defines this vehicle, evidenced by a clean pass on 12 March 2026 and a general absence of failures across five recorded tests. While the record is largely clear, a brief period of wear on front-end consumables occurred in March 2024, but the trend has since returned to a defect-free status in the most recent two inspections. The recorded mileage of 47,371 miles over eight years indicates an average annual usage of approximately 5,921 miles. This low accumulation rate suggests the vehicle has been used significantly less than the national average for its age. Mechanically, this typically results in reduced wear on the engine and drivetrain, although it can lead to different wear patterns on rubber components and braking surfaces compared to high-mileage examples. Specific attention should be directed toward the front braking system and tyre condition due to the advisories recorded in March 2024 regarding worn front tyres and a pitted or scored offside front brake disc. Although the subsequent 2025 and 2026 tests were clean, suggesting these components may have been replaced or refurbished, a physical inspection of the current tyre tread depth and disc surface is advised to confirm the current state of these consumables. During a test drive, focus on the tactile feedback from the braking system to ensure there is no pedal judder or uneven deceleration, which would indicate lingering issues with the brake discs. Additionally, monitor the steering for any pull or drift and listen for unusual noises from the front suspension over uneven surfaces to confirm that the previous edge wear on the tyres was not caused by an underlying alignment or suspension geometry fault.