2019 Volkswagen Crafter 2.0L Diesel · FN69 LLP

The most recent DVSA MOT test for the 2019 Volkswagen Crafter was conducted on 2025-12-22 and resulted in a passing outcome, with a single advisory noted regarding the offside rear light lens being cracked but not emitting a white light. This advisory is relatively minor and does not impact the vehicle’s roadworthiness, though it indicates a potential long-term risk if the lens continues to degrade, potentially compromising rear visibility in poor conditions. The MOT history over the past four years shows a consistent trend of passing tests without significant recurring defects, suggesting a generally stable maintenance record. The absence of repeated failures or advisories over this period is encouraging, though the advisory itself warrants closer attention during a pre-purchase inspection to ensure no underlying issues are exacerbated by the crack. The recorded mileage of 149,662 miles for a 2019 model represents a high annual usage rate of approximately 21,380 miles per year, which is notably elevated for its age. Such mileage accumulation typically accelerates wear on critical components, including suspension bushings, brake pads and discs, drivetrain seals, and exhaust system components. The rapid mileage suggests the vehicle has been subjected to frequent driving, potentially including stop-and-go traffic, which can accelerate brake and suspension degradation. Additionally, the absence of significant mileage gaps implies the vehicle has been in regular use rather than standing idle for extended periods, which could otherwise mitigate some wear effects. Buyers should be cautious of potential hidden wear in these areas, particularly if the vehicle has been driven in conditions that exacerbate friction or vibration. Given the MOT history and the vehicle’s age and mileage, the most critical areas to inspect during a pre-purchase examination include the suspension system, brakes, and drivetrain components. The offside rear light lens advisory should be verified for any signs of further deterioration, such as increased glare or potential electrical issues that could affect rear visibility. On a test drive, listen for unusual noises from the suspension, such as clunks or rattles, which could indicate worn or failing suspension bushes, coil springs, or lower control arms. Inspect the brakes for uneven wear, binding calipers, or excessive heat discolouration on the discs, which may signal underlying issues like warping or hydraulic failure. Pay particular attention to the brake fluid level and condition, as brake fluid absorbs moisture over time, reducing effectiveness and risking hydraulic lock-up. For a 2019 Volkswagen Crafter with 149,662 miles, the next major fluid servicing intervals should be considered, particularly for the engine oil and coolant, which should be replaced according to the manufacturer’s recommendations—typically every 60,000 to 100,000 miles or every 12 months, whichever comes first. Given the high mileage, the engine oil and filter should be fresh, and the coolant system should be checked for signs of contamination or corrosion. The 12-volt battery should also be tested for strength, especially if the vehicle has been driven frequently, as prolonged use can lead to reduced charge capacity. Inspect the tyres for signs of sidewall cracking or perishing, which can occur even at lower mileages due to age-related degradation, and ensure they meet the minimum legal tread depth of 1.6mm. Finally, verify that the service book is up to date, as the manufacturer’s recommended maintenance schedule for a high-mileage vehicle should include regular checks of the drivetrain seals, exhaust system for leaks, and transmission fluid condition. A thorough inspection of the exhaust emissions system is also advisable, as high mileage can lead to increased carbon buildup or catalytic converter degradation.